Hi Koen,
Just noticed there should be generic node names here too, see below.
* Koen Kooi <koen@xxxxxxxxxxxxxxxxxxxxx> [180713 06:28]:
> The "Beaglebone Enhanced" by Sancloud is based on the Beaglebone Black,
> but with the following differences:
>
> * Gigabit capable PHY
> * Extra USB hub, optional i2c control
> * lps3331ap barometer connected over i2c
> * MPU6050 6 axis MEMS accelerometer/gyro connected over i2c
> * 1GiB DDR3 RAM
> * RTL8723 Wifi/Bluetooth connected over USB
> +&i2c0 {
> + lps331ap: lps331ap@5C {
> + compatible = "st,lps331ap-press";
> + st,drdy-int-pin = <1>;
> + reg = <0x5C>;
> + interrupt-parent = <&gpio1>;
> + interrupts = <26 IRQ_TYPE_EDGE_RISING>;
> + };
lps33lap: barometer@5c
> + mpu6050: mpu6050@68 {
> + compatible = "invensense,mpu6050";
> + reg = <0x68>;
> + interrupt-parent = <&gpio0>;
> + interrupts = <2 IRQ_TYPE_EDGE_RISING>;
> + orientation = <0xff 0 0 0 1 0 0 0 0xff>;
> + };
mpu6050: accelerometer@2c
And so on. Please check the lower case hex numbers too as
that's what Linux typically uses.
Thanks,
Tony
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
