Re: [PATCH 6/6] soc/tegra: pmc: Implement pad configuration via pinctrl

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 11/07/18 11:12, Aapo Vienamo wrote:
> On Wed, 11 Jul 2018 10:46:21 +0100
> Jon Hunter <jonathanh@xxxxxxxxxx> wrote:
> 
>> On 11/07/18 10:38, Aapo Vienamo wrote:
>>> On Wed, 11 Jul 2018 09:40:01 +0100
>>> Jon Hunter <jonathanh@xxxxxxxxxx> wrote:
>>>   
>>>> On 10/07/18 13:54, Aapo Vienamo wrote:  
>>>>> Register a pinctrl device and implement get and set functions for
>>>>> PIN_CONFIG_LOW_POWER_MODE and PIN_CONFIG_POWER_SOURCE parameters.
>>>>>
>>>>> Signed-off-by: Aapo Vienamo <avienamo@xxxxxxxxxx>
>>>>> ---
>>>>>  drivers/soc/tegra/pmc.c | 192 +++++++++++++++++++++++++++++++++++++++++++++++-
>>>>>  1 file changed, 190 insertions(+), 2 deletions(-)
>>>>>
>>>>> diff --git a/drivers/soc/tegra/pmc.c b/drivers/soc/tegra/pmc.c
>>>>> index b833334..8677391 100644
>>>>> --- a/drivers/soc/tegra/pmc.c
>>>>> +++ b/drivers/soc/tegra/pmc.c
>>>>> @@ -33,6 +33,9 @@
>>>>>  #include <linux/of_address.h>
>>>>>  #include <linux/of_clk.h>
>>>>>  #include <linux/of_platform.h>
>>>>> +#include <linux/pinctrl/pinctrl.h>
>>>>> +#include <linux/pinctrl/pinconf.h>
>>>>> +#include <linux/pinctrl/pinconf-generic.h>
>>>>>  #include <linux/platform_device.h>
>>>>>  #include <linux/pm_domain.h>
>>>>>  #include <linux/reboot.h>
>>>>> @@ -45,6 +48,8 @@
>>>>>  #include <soc/tegra/fuse.h>
>>>>>  #include <soc/tegra/pmc.h>
>>>>>  
>>>>> +#include <dt-bindings/pinctrl/pinctrl-tegra-io-pad.h>
>>>>> +
>>>>>  #define PMC_CNTRL			0x0
>>>>>  #define  PMC_CNTRL_INTR_POLARITY	BIT(17) /* inverts INTR polarity */
>>>>>  #define  PMC_CNTRL_CPU_PWRREQ_OE	BIT(16) /* CPU pwr req enable */
>>>>> @@ -162,6 +167,9 @@ struct tegra_pmc_soc {
>>>>>  	const struct tegra_io_pad_soc *io_pads;
>>>>>  	unsigned int num_io_pads;
>>>>>  
>>>>> +	const struct pinctrl_pin_desc *pin_descs;
>>>>> +	unsigned int num_pin_descs;
>>>>> +
>>>>>  	const struct tegra_pmc_regs *regs;
>>>>>  	void (*init)(struct tegra_pmc *pmc);
>>>>>  	void (*setup_irq_polarity)(struct tegra_pmc *pmc,
>>>>> @@ -220,6 +228,8 @@ struct tegra_pmc {
>>>>>  	DECLARE_BITMAP(powergates_available, TEGRA_POWERGATE_MAX);
>>>>>  
>>>>>  	struct mutex powergates_lock;
>>>>> +
>>>>> +	struct pinctrl_dev *pctl_dev;
>>>>>  };
>>>>>  
>>>>>  static struct tegra_pmc *pmc = &(struct tegra_pmc) {
>>>>> @@ -1400,6 +1410,145 @@ static void tegra_pmc_init_tsense_reset(struct tegra_pmc *pmc)
>>>>>  	of_node_put(np);
>>>>>  }
>>>>>  
>>>>> +static int tegra_io_pad_pinctrl_get_groups_count(struct pinctrl_dev *pctl_dev)
>>>>> +{
>>>>> +	return pmc->soc->num_io_pads;
>>>>> +}
>>>>> +
>>>>> +static const char *tegra_io_pad_pinctrl_get_group_name(
>>>>> +		struct pinctrl_dev *pctl, unsigned int group)
>>>>> +{
>>>>> +	return pmc->soc->io_pads[group].name;
>>>>> +}
>>>>> +
>>>>> +static int tegra_io_pad_pinctrl_get_group_pins(struct pinctrl_dev *pctl_dev,
>>>>> +					       unsigned int group,
>>>>> +					       const unsigned int **pins,
>>>>> +					       unsigned int *num_pins)
>>>>> +{
>>>>> +	*pins = &pmc->soc->io_pads[group].id;
>>>>> +	*num_pins = 1;
>>>>> +	return 0;
>>>>> +}
>>>>> +
>>>>> +static const struct pinctrl_ops tegra_io_pad_pinctrl_ops = {
>>>>> +	.get_groups_count = tegra_io_pad_pinctrl_get_groups_count,
>>>>> +	.get_group_name = tegra_io_pad_pinctrl_get_group_name,
>>>>> +	.get_group_pins = tegra_io_pad_pinctrl_get_group_pins,
>>>>> +	.dt_node_to_map = pinconf_generic_dt_node_to_map_pin,
>>>>> +	.dt_free_map = pinconf_generic_dt_free_map,
>>>>> +};
>>>>> +
>>>>> +static int tegra_io_pad_pinconf_get(struct pinctrl_dev *pctl_dev,
>>>>> +				    unsigned int pin, unsigned long *config)
>>>>> +{
>>>>> +	const struct tegra_io_pad_soc *pad = tegra_io_pad_find(pmc, pin);
>>>>> +	enum pin_config_param param = pinconf_to_config_param(*config);
>>>>> +	int ret;
>>>>> +	u32 arg;
>>>>> +
>>>>> +	switch (param) {
>>>>> +	case PIN_CONFIG_POWER_SOURCE:
>>>>> +		ret = tegra_io_pad_get_voltage(pad->id);
>>>>> +		if (ret == TEGRA_IO_PAD_1800000UV)
>>>>> +			arg = TEGRA_IO_PAD_VOLTAGE_1V8;
>>>>> +		else if (ret == TEGRA_IO_PAD_3300000UV)
>>>>> +			arg = TEGRA_IO_PAD_VOLTAGE_3V3;    
>>>>
>>>> It looks like we have two definitions for the same thing here.
>>>> Can we get rid of one of these?   
>>>
>>> They are indeed pretty much the same thing, however
>>> TEGRA_IO_PAD_1800000UV is part of the pmc.h api and
>>> TEGRA_IO_PAD_VOLTAGE_1V8 comes from the device tree binding abi headers.
>>> The key difference between them is that TEGRA_IO_PAD_VOLTAGE_1V8 is a
>>> macro and TEGRA_IO_PAD_1800000UV is an enum and it's used like this in
>>> the pmc api:
>>>
>>> int tegra_io_pad_set_voltage(enum tegra_io_pad id,
>>>                              enum tegra_io_pad_voltage voltage);
>>>
>>> where it's obvious that the function takes this enum as an argument. If
>>> the enum definitions were replaced with macros usable from the dts
>>> files, the enum from the function prototype would have to be changed to
>>> an int. This makes the api more ambiguous because other parts of the
>>> kernel have the convention where "int voltage" means voltage in
>>> microvolts.  
>>
>> Raises the question, do we need these legacy APIs? I don't see them being
>> used.
>>
> 
> True, however other parts of the pmc pad configuration API are used, for
> example tegra_io_pad_power_enable() and _disable() are used by the sor
> driver.
> 
> I see couple of options here: For sake of consistency we could merge
> this as is and later replace all of the existing usage of the pmc.h pad
> control API with pinctrl in a separate series and clean that part up.
> Or I could remove the pad voltage configuration API as part of this
> series and leave the pmc.h pad power state API the way it is. Or I could
> transition the existing usage of pmc pad control to use the pinctrl API
> but I'm not sure if that's within the scope of this series.
> 
> Any thoughts?

My preference would be option #2 ...

"remove the pad voltage configuration API as part of this series and
 leave the pmc.h pad power state API the way it is".

If someone is using the tegra_io_pad_power_enable/disable then we cannot
get rid of it, but we can get rid of the other legacy APIs.

Cheers
Jon

-- 
nvpublic
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux