Describe the bindings for EETI touchscreen controllers.
Signed-off-by: Daniel Mack <daniel@xxxxxxxxxx>
---
.../bindings/input/touchscreen/eeti.txt | 31 +++++++++++++++++++
1 file changed, 31 insertions(+)
create mode 100644 Documentation/devicetree/bindings/input/touchscreen/eeti.txt
diff --git a/Documentation/devicetree/bindings/input/touchscreen/eeti.txt b/Documentation/devicetree/bindings/input/touchscreen/eeti.txt
new file mode 100644
index 000000000000..69c32c286ec7
--- /dev/null
+++ b/Documentation/devicetree/bindings/input/touchscreen/eeti.txt
@@ -0,0 +1,31 @@
+Bindings for EETI touchscreen controller
+
+Required properties:
+- compatible: should be "eeti,exc3000-i2c"
+- reg: I2C address of the chip. Should be set to <0xa>
+- interrupts: interrupt to which the chip is connected
+
+Optional properties:
+- attn-gpios: A handle to a GPIO to check whether interrupt is still
+ latched. This is necessary for platforms that lack
+ support for level-triggered IRQs.
+
+The following optional properties described in touchscreen.txt are
+also supported:
+
+- touchscreen-inverted-x
+- touchscreen-inverted-y
+- touchscreen-swapped-x-y
+
+Example:
+
+i2c-master {
+ touchscreen@a {
+ compatible = "eeti,exc3000-i2c";
+ reg = <0xa>;
+ interrupt-parent = <&gpio>;
+ interrupts = <123 IRQ_TYPE_EDGE_RISING>;
+ attn-gpios = <&gpio 123 GPIO_ACTIVE_HIGH>;
+ };
+};
+
--
2.17.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
