1. If nand-ecc-strength specified in DT, then controller will use this ECC strength otherwise ECC strength will be calculated according to chip requirement and available OOB size. 2. QCOM NAND controller supports only one step size (512 bytes) but nand-ecc-step-size is required property in DT. This DT property can be removed and ecc step size can be assigned in driver with 512 bytes value. Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx> --- * Changes from v3: 1. Clubbed following 2 patches into one https://patchwork.ozlabs.org/patch/920465/ https://patchwork.ozlabs.org/patch/920467/ * Changes from v2: NONE * Changes from v1: NEW PATCH Documentation/devicetree/bindings/mtd/qcom_nandc.txt | 7 +++---- 1 file changed, 3 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt index 73d336be..1123cc6 100644 --- a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt +++ b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt @@ -45,11 +45,12 @@ Required properties: number (e.g., 0, 1, 2, etc.) - #address-cells: see partition.txt - #size-cells: see partition.txt -- nand-ecc-strength: see nand.txt -- nand-ecc-step-size: must be 512. see nand.txt for more details. Optional properties: - nand-bus-width: see nand.txt +- nand-ecc-strength: see nand.txt. If not specified, then ECC strength will + be used according to chip requirement and available + OOB size. Each nandcs device node may optionally contain a 'partitions' sub-node, which further contains sub-nodes describing the flash partition mapping. See @@ -77,7 +78,6 @@ nand-controller@1ac00000 { reg = <0>; nand-ecc-strength = <4>; - nand-ecc-step-size = <512>; nand-bus-width = <8>; partitions { @@ -117,7 +117,6 @@ nand-controller@79b0000 { nand@0 { reg = <0>; nand-ecc-strength = <4>; - nand-ecc-step-size = <512>; nand-bus-width = <8>; partitions { -- QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
