Hi Geert,
Thank you for the patch.
Overall the series is great. I ran some time ago into issues with CCF due to
the driver use of spi-bitbang, I'm happy to see this being fixed, thanks a
lot. I have one small comment below though.
On Tuesday 25 February 2014 11:21:10 Geert Uytterhoeven wrote:
> From: Geert Uytterhoeven <geert+renesas@xxxxxxxxxxxxxx>
>
> Add support for the MSIOF variant in the R-Car H2 (r8a7790) and M2
> (r8a7791) SoCs.
>
> Binding documentation:
> - Add future-proof "renesas,msiof-<soctype>" compatible values,
> - The default for "renesas,rx-fifo-size" is 256 on R-Car H2 and M2,
> - "renesas,tx-fifo-size" and "renesas,rx-fifo-size" are deprecated for
> soctype-specific bindings,
> - Add example bindings.
>
> Implementation:
> - MSIOF on R-Car H2 and M2 requires the transmission of dummy data if
> data is being received only (cfr. "Set SICTR.TSCKE to 1" and "Write
> dummy transmission data to SITFDR" in paragraph "Transmit and Receive
> Procedures" of the Hardware User's Manual).
> - As RX depends on TX, MSIOF on R-Car H2 and M2 also lacks the RSCR
> register (Receive Clock Select Register), and some bits in the RMDR1
> (Receive Mode Register 1) and TMDR2 (Transmit Mode Register 2)
> registers.
> - Use the recently introduced SPI_MASTER_MUST_TX flag to enable support
> for dummy transmission in the SPI core, and to differentiate from other
> MSIOF implementations in code paths that need this.
> - New DT compatible values ("renesas,msiof-r8a7790" and
> "renesas,msiof-r8a7791") are added, as well as new platform device
> names ("spi_r8a7790_msiof" and "spi_r8a7791_msiof").
> - The default RX FIFO size is 256 words on R-Car H2 and M2.
>
> This is loosely based on a set of patches from Takashi Yoshii
> <takasi-y@xxxxxxxxxxxxx>.
>
> Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxxxxxxx>
> Cc: Takashi Yoshii <takasi-y@xxxxxxxxxxxxx>
> Cc: devicetree@xxxxxxxxxxxxxxx
> ---
> v2:
> - Rebased on top of new "spi: sh-msiof: Move default FIFO sizes to device
> ID data",
> - The default RX FIFO size is 256 words on R-Car H2 and M2,
> - Deprecated overriding the FIFO size,
> - Synced DT example with node from real DTS.
>
> Documentation/devicetree/bindings/spi/sh-msiof.txt | 23 +++++++++++++++--
> drivers/spi/spi-sh-msiof.c | 23 ++++++++++++++---
> 2 files changed, 41 insertions(+), 5 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/spi/sh-msiof.txt
> b/Documentation/devicetree/bindings/spi/sh-msiof.txt index
> eae3c8c9300e..1f0cb33763a1 100644
> --- a/Documentation/devicetree/bindings/spi/sh-msiof.txt
> +++ b/Documentation/devicetree/bindings/spi/sh-msiof.txt
> @@ -1,8 +1,13 @@
> Renesas MSIOF spi controller
>
> Required properties:
> -- compatible : "renesas,sh-msiof" for SuperH, or
> +- compatible : "renesas,msiof-<soctype>" for SoCs,
> + "renesas,sh-msiof" for SuperH, or
> "renesas,sh-mobile-msiof" for SH Mobile series.
> + Examples with soctypes are:
> + "renesas,msiof-sh7724" (SH)
Given that the driver doesn't handle the "renesas,msiof-sh7724" compatible
string this might not be a good example. Furthermore SuperH doesn't have DT
support. I would thus drop the "renesas,sh-msiof" compatible string from patch
1/6 and wouldn't mention sh7724 here. I very much doubt that someone would
have developed DT support for SuperH on the side and shipped products that
would be broken by this change :-)
> + "renesas,msiof-r8a7790" (R-Car H2)
> + "renesas,msiof-r8a7791" (R-Car M2)
> - reg : Offset and length of the register set for the
> device - interrupt-parent : The phandle for the interrupt controller
> that services interrupts for this device
> @@ -13,10 +18,24 @@ Required properties:
> Optional properties:
> - clocks : Must contain a reference to the functional clock.
> - num-cs : Total number of chip-selects (default is 1)
> +
> +Optional properties, deprecated for soctype-specific bindings:
> - renesas,tx-fifo-size : Overrides the default tx fifo size given in words
> (default is 64)
> - renesas,rx-fifo-size : Overrides the default rx fifo size given in words
> - (default is 64)
> + (default is 64, or 256 on R-Car H2 and M2)
>
> Pinctrl properties might be needed, too. See
> Documentation/devicetree/bindings/pinctrl/renesas,*.
> +
> +Example:
> +
> + msiof0: spi@e6e20000 {
> + compatible = "renesas,msiof-r8a7791";
> + reg = <0 0xe6e20000 0 0x0064>;
> + interrupts = <0 156 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&mstp0_clks R8A7791_CLK_MSIOF0>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> + status = "disabled";
> + };
> diff --git a/drivers/spi/spi-sh-msiof.c b/drivers/spi/spi-sh-msiof.c
> index bf389184924d..3baef2bacaed 100644
> --- a/drivers/spi/spi-sh-msiof.c
> +++ b/drivers/spi/spi-sh-msiof.c
> @@ -34,6 +34,7 @@
> struct sh_msiof_chipdata {
> u16 tx_fifo_size;
> u16 rx_fifo_size;
> + u16 master_flags;
> };
>
> struct sh_msiof_spi_priv {
> @@ -214,7 +215,8 @@ static void sh_msiof_spi_set_clk_regs(struct
> sh_msiof_spi_priv *p, k = min_t(int, k, ARRAY_SIZE(sh_msiof_spi_clk_table)
> - 1);
>
> sh_msiof_write(p, TSCR, sh_msiof_spi_clk_table[k].scr);
> - sh_msiof_write(p, RSCR, sh_msiof_spi_clk_table[k].scr);
> + if (!(p->chipdata->master_flags & SPI_MASTER_MUST_TX))
> + sh_msiof_write(p, RSCR, sh_msiof_spi_clk_table[k].scr);
> }
>
> static void sh_msiof_spi_set_pin_regs(struct sh_msiof_spi_priv *p,
> @@ -237,6 +239,10 @@ static void sh_msiof_spi_set_pin_regs(struct
> sh_msiof_spi_priv *p, tmp |= !cs_high << MDR1_SYNCAC_SHIFT;
> tmp |= lsb_first << MDR1_BITLSB_SHIFT;
> sh_msiof_write(p, TMDR1, tmp | MDR1_TRMD | TMDR1_PCON);
> + if (p->chipdata->master_flags & SPI_MASTER_MUST_TX) {
> + /* These bits are reserved if RX needs TX */
> + tmp &= ~0x0000ffff;
> + }
> sh_msiof_write(p, RMDR1, tmp);
>
> tmp = 0;
> @@ -257,7 +263,7 @@ static void sh_msiof_spi_set_mode_regs(struct
> sh_msiof_spi_priv *p, {
> u32 dr2 = MDR2_BITLEN1(bits) | MDR2_WDLEN1(words);
>
> - if (tx_buf)
> + if (tx_buf || (p->chipdata->master_flags & SPI_MASTER_MUST_TX))
> sh_msiof_write(p, TMDR2, dr2);
> else
> sh_msiof_write(p, TMDR2, dr2 | MDR2_GRPMASK1);
> @@ -666,11 +672,20 @@ static u32 sh_msiof_spi_txrx_word(struct spi_device
> *spi, unsigned nsecs, static const struct sh_msiof_chipdata sh_data = {
> .tx_fifo_size = 64,
> .rx_fifo_size = 64,
> + .master_flags = 0,
> +};
> +
> +static const struct sh_msiof_chipdata r8a779x_data = {
> + .tx_fifo_size = 64,
> + .rx_fifo_size = 256,
> + .master_flags = SPI_MASTER_MUST_TX,
> };
>
> static const struct of_device_id sh_msiof_match[] = {
> { .compatible = "renesas,sh-msiof", .data = &sh_data },
> { .compatible = "renesas,sh-mobile-msiof", .data = &sh_data },
> + { .compatible = "renesas,msiof-r8a7790", .data = &r8a779x_data },
> + { .compatible = "renesas,msiof-r8a7791", .data = &r8a779x_data },
> {},
> };
> MODULE_DEVICE_TABLE(of, sh_msiof_match);
> @@ -789,7 +804,7 @@ static int sh_msiof_spi_probe(struct platform_device
> *pdev) /* init master and bitbang code */
> master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH;
> master->mode_bits |= SPI_LSB_FIRST | SPI_3WIRE;
> - master->flags = 0;
> + master->flags = p->chipdata->master_flags;
> master->bus_num = pdev->id;
> master->dev.of_node = pdev->dev.of_node;
> master->num_chipselect = p->info->num_chipselect;
> @@ -832,6 +847,8 @@ static int sh_msiof_spi_remove(struct platform_device
> *pdev)
>
> static struct platform_device_id spi_driver_ids[] = {
> { "spi_sh_msiof", (kernel_ulong_t)&sh_data },
> + { "spi_r8a7790_msiof", (kernel_ulong_t)&r8a779x_data },
> + { "spi_r8a7791_msiof", (kernel_ulong_t)&r8a779x_data },
> {},
> };
> MODULE_DEVICE_TABLE(platform, spi_driver_ids);
--
Regards,
Laurent Pinchart
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
