Add documentation for Aptina MT9V111 image sensor.
Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
---
.../bindings/media/i2c/aptina,mt9v111.txt | 46 ++++++++++++++++++++++
1 file changed, 46 insertions(+)
create mode 100644 Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt
diff --git a/Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt b/Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt
new file mode 100644
index 0000000..bac4bf0
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt
@@ -0,0 +1,46 @@
+* Aptina MT9V111 CMOS sensor
+----------------------------
+
+The Aptina MT9V111 is a 1/4-Inch VGA-format digital image sensor with a core
+based on Aptina MT9V011 sensor and an integrated Image Flow Processor (IFP).
+
+The sensor has an active pixel array of 649x489 pixels and can output a number
+of image resolution and formats controllable through a simple two-wires
+interface.
+
+Required properties:
+--------------------
+
+- compatible: shall be "aptina,mt9v111".
+- clocks: reference to the system clock input provider.
+
+Optional properties:
+--------------------
+
+- enable-gpios: output enable signal, pin name "OE#". Active low.
+- standby-gpios: low power state control signal, pin name "STANDBY".
+ Active high.
+- reset-gpios: chip reset signal, pin name "RESET#". Active low.
+
+The device node must contain one 'port' child node with one 'endpoint' child
+sub-node for its digital output video port, in accordance with the video
+interface bindings defined in:
+Documentation/devicetree/bindings/media/video-interfaces.txt
+
+Example:
+--------
+
+ &i2c1 {
+ camera@48 {
+ compatible = "aptina,mt9v111";
+ reg = <0x48>;
+
+ clocks = <&camera_clk>;
+
+ port {
+ mt9v111_out: endpoint {
+ remote-endpoint = <&ceu_in>;
+ };
+ };
+ };
+ };
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
