Hi,
On 5/29/2018 10:07 AM, Can Guo wrote:
> All PHYs should be powered on before register configuration starts. And
> only PCIe PHYs need an extra power control before deasserts reset state.
>
> Signed-off-by: Can Guo <cang@xxxxxxxxxxxxxx>
> ---
> drivers/phy/qualcomm/phy-qcom-qmp.c | 5 ++++-
> 1 file changed, 4 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c
> index 97ef942..f779b0f 100644
> --- a/drivers/phy/qualcomm/phy-qcom-qmp.c
> +++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
> @@ -982,6 +982,8 @@ static int qcom_qmp_phy_com_init(struct qcom_qmp *qmp)
> if (cfg->has_phy_com_ctrl)
> qphy_setbits(serdes, cfg->regs[QPHY_COM_POWER_DOWN_CONTROL],
> SW_PWRDN);
> + else
> + qphy_setbits(pcs, QPHY_POWER_DOWN_CONTROL, cfg->pwrdn_ctrl);
We should power-up PHYs after following dp_com_ctrl programming which
powers-off USB-DP combo PHY when it brings DP_COM block out of reset reset.
>
> if (cfg->has_phy_dp_com_ctrl) {
> qphy_setbits(dp_com, QPHY_V3_DP_COM_POWER_DOWN_CTRL,
> @@ -1127,7 +1129,8 @@ static int qcom_qmp_phy_init(struct phy *phy)
> * Pull out PHY from POWER DOWN state.
> * This is active low enable signal to power-down PHY.
> */
> - qphy_setbits(pcs, QPHY_POWER_DOWN_CONTROL, cfg->pwrdn_ctrl);
> + if (cfg->type == PHY_TYPE_PCIE)
> + qphy_setbits(pcs, QPHY_POWER_DOWN_CONTROL, cfg->pwrdn_ctrl);
>
> if (cfg->has_pwrdn_delay)
> usleep_range(cfg->pwrdn_delay_min, cfg->pwrdn_delay_max);
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
