The following sensors are on I2C3 on the baseboard:
* isil,isl29023 light sensor
* fsl,mag3110 magnetometer
* fsl,mma8451 accelerometer
Added under i2cmux/i2c@1 because they're not otherwise accessible.
These are all supported by iio with following configs:
* CONFIG_SENSORS_ISL29018
* CONFIG_MAG3110
* CONFIG_MMA8452
Tested with raw reads from iio sysfs.
Signed-off-by: Leonard Crestez <leonard.crestez@xxxxxxx>
---
arch/arm/boot/dts/imx6qdl-sabreauto.dtsi | 21 +++++++++++++++++++++
1 file changed, 21 insertions(+)
diff --git a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
index 54b0139e978d..a6193240259d 100644
--- a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
@@ -160,10 +160,31 @@
compatible = "maxim,max7310";
reg = <0x34>;
gpio-controller;
#gpio-cells = <2>;
};
+
+ isl29023@44 {
+ compatible = "isil,isl29023";
+ reg = <0x44>;
+ interrupt-parent = <&gpio5>;
+ interrupts = <17 IRQ_TYPE_EDGE_FALLING>;
+ };
+
+ mag3110@0e {
+ compatible = "fsl,mag3110";
+ reg = <0x0e>;
+ interrupt-parent = <&gpio2>;
+ interrupts = <29 IRQ_TYPE_EDGE_RISING>;
+ };
+
+ mma8451@1c {
+ compatible = "fsl,mma8451";
+ reg = <0x1c>;
+ interrupt-parent = <&gpio6>;
+ interrupts = <31 IRQ_TYPE_LEVEL_LOW>;
+ };
};
};
};
&ipu1_csi0_from_ipu1_csi0_mux {
--
2.17.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
