On Fri, Jun 01, 2018 at 04:58:27PM +0200, jacopo mondi wrote: > Hi Sakari, > > On Fri, Jun 01, 2018 at 01:29:10PM +0300, Sakari Ailus wrote: > > Hi Jacopo, > > > > Thanks for the patch. > > > > On Tue, May 29, 2018 at 05:05:53PM +0200, Jacopo Mondi wrote: > > > Add 'data-enable-active' property to endpoint node properties list. > > > > > > The property allows to specify the polarity of the data-enable signal, which > > > when in active state determinates when data lanes have to sampled for valid > > > pixel data. > > > > Lanes or lines? I understand this is forthe parallel interface. > > > > Now I'm confused. Are the parallel data 'lines' and the CSI-2 one > 'lanes'? I thought 'lanes' applies to both.. am I wrong? "Lane" is conventionally refer to a differential pair of wires on a serial bus such as CSI-2. "Line" is used of a wire on a parallel bus. -- Sakari Ailus sakari.ailus@xxxxxxxxxxxxxxx -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
