On 05/23/2018 02:08 PM, Geert Uytterhoeven wrote: > Hi Marek, > > On Wed, May 23, 2018 at 1:26 PM, Marek Vasut <marek.vasut@xxxxxxxxx> wrote: >> Add device tree bindings for the Dialog DA9063L. This is a >> variant of the DA9063 chip with smaller package, with less >> LDO regulators and without RTC block. The other properties >> of the chip are the same, including the content of the chip >> ID register. >> >> Signed-off-by: Marek Vasut <marek.vasut+renesas@xxxxxxxxx> > > Thanks for your patch! > > Reviewed-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> > > Minor nit below. > >> --- a/Documentation/devicetree/bindings/mfd/da9063.txt >> +++ b/Documentation/devicetree/bindings/mfd/da9063.txt > >> @@ -6,14 +6,14 @@ Device Supply Names Description >> ------ ------------ ----------- >> da9063-regulator : : LDOs & BUCKs >> da9063-onkey : : On Key >> -da9063-rtc : : Real-Time Clock >> +da9063-rtc : : Real-Time Clock (DA9063 only) >> da9063-watchdog : : Watchdog >> >> ====== >> >> Required properties: >> >> -- compatible : Should be "dlg,da9063" >> +- compatible : Should be "dlg,da9063" or "dlg,da9063l" >> - reg : Specifies the I2C slave address (this defaults to 0x58 but it can be >> modified to match the chip's OTP settings). >> - interrupt-parent : Specifies the reference to the interrupt controller for >> @@ -23,8 +23,8 @@ Required properties: >> >> Sub-nodes: >> >> -- regulators : This node defines the settings for the LDOs and BUCKs. The >> - DA9063 regulators are bound using their names listed below: >> +- regulators : This node defines the settings for the LDOs and BUCKs. >> + The DA9063 regulators are bound using their names listed below: >> >> bcore1 : BUCK CORE1 >> bcore2 : BUCK CORE2 >> @@ -44,13 +44,28 @@ Sub-nodes: >> ldo10 : LDO_10 >> ldo11 : LDO_11 >> >> + The DA9063L regulators are bound using their names listed below: >> + >> + bcore1 : BUCK CORE1 >> + bcore2 : BUCK CORE2 >> + bpro : BUCK PRO >> + bmem : BUCK MEM >> + bio : BUCK IO >> + bperi : BUCK PERI >> + ldo3 : LDO_3 >> + ldo7 : LDO_7 >> + ldo8 : LDO_8 >> + ldo9 : LDO_9 >> + ldo11 : LDO_11 >> + > > As an alternative to having two lists, perhaps you can use a table, or > mark entries "(DA9063 only)", like you did for da9063-rtc above? > That makes it easier to see the differences. Let's try that in V2 -- Best regards, Marek Vasut -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
