On Thu, May 17, 2018 at 09:14:56AM +0200, jacopo mondi wrote: > Hi Niklas, > > On Thu, May 17, 2018 at 12:23:18AM +0200, Niklas Söderlund wrote: > > Hi Jacopo, > > > > Thanks for your patch. > > > > On 2018-05-16 15:42:09 +0200, Jacopo Mondi wrote: > > > Describe HDMI input connector and ADV7612 HDMI decoder installed on > > > R-Car Gen3 Draak board. > > > > > > The video signal routing to the HDMI decoder to the video input interface > > > VIN4 is multiplexed with CVBS input path, and enabled/disabled through > > > on-board switches SW-49, SW-50, SW-51 and SW-52. > > > > > > As the default board switches configuration connects CVBS input to VIN4, > > > leave the HDMI decoder unconnected in DTS. > > > > > > Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx> > > > > I'm not sure we have a policy about describing hardware which can't be > > used without flipping switches. I have no opinion on if we should do > > that or not I leave that to others, but for the change itself. > > > > Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx> > > > > Thanks > > > I think it's good we describe it as it's part of the Draak board itself > > and not an expansion board which we have seen a lot of :-) Maybe even > > add a commented out line in the adv7612 port@2 which hints which VIN > > this is connected to if the switches are flipped? > > The only VIN instance that's on Draak, VIN4. > > I can add a comment that describes the switch settings that enables > the HDMI video capture path. That sounds like a good plan to me. -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
