>
> * Eyal Reizer <eyalreizer@xxxxxxxxx> [180501 00:26]:
> > enable mmc3 used for wlan and uart1 used for bluetooth
> > configure the gpios used for wlan and bluetooth controls
> > add fixed voltage regulator used for wlan power control
> ...
> > / {
> > model = "TI AM437x SK EVM";
> > @@ -158,6 +159,22 @@
> > };
> > };
> > };
> > +
> > + vmmcwl_fixed: fixedregulator-mmcwl {
> > + /*
> > + * WL_EN is not SDIO standard compliant. It is an out of band
> > + * signal and hard to be dealt with in a standard way by the
> > + * SDIO core driver.
> > + * So modelling the WL_EN line as a regulator was a natural
> > + * choice as the MMC core already deals with MMC supplies.
> > + */
> > + compatible = "regulator-fixed";
> > + regulator-name = "vmmcwl_fixed";
> > + regulator-min-microvolt = <1800000>;
> > + regulator-max-microvolt = <1800000>;
> > + gpio = <&gpio4 8 GPIO_ACTIVE_HIGH>;
> > + enable-active-high;
> > + };
> > };
>
> Interesting that it needs much longer delay here compared to the
> earlier?
Where do you see a delay in here?
There is no startup-delay-us value used in this patch.
>
> BTW, I do have a patch in work to add pwrseq support for wlcore that
> allows leaving out the regulator here. It still needs a bit more
> work though.
>
> And I also have a series in work to make wlcore use runtime PM that
> needs even more work, just FYI to avoid any duplicate work.
>
> Hmm you don't happen to have a patch series somewhere making
> wlcore use the SDIO dat lien interrupt?
wilink has always used out of band interrupt (using wlan_irq gpio).
in-band interrupts was not supported.
See section 10.5.2 in this the wl18xx hardware integration guide:
http://www.ti.com/lit/ug/swru437/swru437.pdf
>
> I think we should use that when idle rather than the (edge) gpio
> interrupt as the SDIO dat interrupt is level sensitive and wired
> to the always on gpio bank for most SDIO controller instances.
> On runtime PM wakeup, there's no status anywhere to been with the
> GPIO edge interrupt.
>
I agree that it would have been better, especially for cases such as wake
On wlan, but again, in-band interrupt was something that was talked
about way back but it was never implemented.
Best Regards,
Eyal
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
