On Tuesday 01 May 2018 12:54 PM, Eyal Reizer wrote:
> enable mmc3 used for wlan and uart1 used for bluetooth
> configure the gpios used for wlan and bluetooth controls
> add fixed voltage regulator used for wlan power control
>
> Signed-off-by: Eyal Reizer <eyalr@xxxxxx>
ARM should be capitalized in subject line.
> +
> +&mmc3 {
> + status = "okay";
> + /*
> + * these are on the crossbar and are outlined in the
> + * xbar-event-map element
> + */
> + dmas = <&edma_xbar 30 0 1>,
> + <&edma_xbar 31 0 2>;
> + dma-names = "tx", "rx";
> + vmmc-supply = <&vmmcwl_fixed>;
> + bus-width = <4>;
> + pinctrl-names = "default", "sleep";
> + pinctrl-0 = <&mmc3_pins_default>;
> + pinctrl-1 = <&mmc3_pins_sleep>;
> + cap-power-off-card;
> + keep-power-in-suspend;
> + ti,non-removable;
> +
> + #address-cells = <1>;
> + #size-cells = <0>;
> + wlcore: wlcore@0 {
wlcore@2
> + compatible = "ti,wl1835";
> + pinctrl-names = "default", "sleep";
> + pinctrl-0 = <&wlan_pins_default>;
> + pinctrl-1 = <&wlan_pins_sleep>;
> + reg = <2>;
> + interrupt-parent = <&gpio4>;
> + interrupts = <13 IRQ_TYPE_LEVEL_HIGH>;
> + };
> +};
Thanks,
Sekhar
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
