This series adds support for generic binding for pinctrl bcm2835 driver, and add the code for set output buffer of a pin using the output-low and output-high generic properties. Tested on Raspberry Pi Zero W, based on bcm2835 SoC. Changes since v6: - I was dumb and calculate the PIN_CONFIG_END (x7f) +1 (x80) and hard coded it. Fix it using recommended define from pinconf-generic.h PIN_CONFIG_END + 1 - In v6 I did not keep the review tags Changes since v5: (Suggested by Stefan Wahren) - Fix checkpatch warnings - Use PIN_CONFIG_END+1 for bcm2835_pinconf_param for our pull legacy configuration (Suggested by Linus Walleij) - Only resend patch 2+3 - Add Stephen Warren for subsequent postings Changes since v4: (Suggested by Rob Herring) - Change dt-bindings docs driver reference to hardware in case the BCM2835 pin configuration and multiplexing Changes since v3: (Suggested by Stefan Wahren) - Change dt-bindings docs patch order and subject Changes since v2: (Suggested by Eric Anholt) - Remove PACK and UNPACK macros - Use pinconf_to_config_* functions (Suggested by Stefan Wahren) - Fold Kconfig changes with the driver changes in a single patch - Add devicetree bindings documentations about generic properties support - Add devicetree bindings maintainers Matheus Castello (2): pinctrl: bcm2835: Add support for generic pinctrl binding pinctrl: bcm2835: Add support for output-low output-high properties drivers/pinctrl/bcm/Kconfig | 1 + drivers/pinctrl/bcm/pinctrl-bcm2835.c | 100 +++++++++++++++++++++------------- 2 files changed, 64 insertions(+), 37 deletions(-) -- 2.7.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
