On 2018-04-19 11:31, Jacopo Mondi wrote:
> The THC63LVD1024 LVDS to RGB bridge supports two different input mapping
> modes, selectable by means of an external pin.
>
> Describe the LVDS mode map through a newly defined mandatory property in
> device tree bindings.
>
> Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
> ---
> .../devicetree/bindings/display/bridge/thine,thc63lvd1024.txt | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
> index 37f0c04..0937595 100644
> --- a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
> +++ b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
> @@ -12,6 +12,8 @@ Required properties:
> - compatible: Shall be "thine,thc63lvd1024"
> - vcc-supply: Power supply for TTL output, TTL CLOCKOUT signal, LVDS input,
> PPL and digital circuitry
> +- thine,map: LVDS mapping mode selection signal, pin name "MAP". Shall be <1>
> + for mapping mode 1, <0> for mapping mode 2
Since the MAP pin is an input pin, I would expect there to be an optional gpio
specifier like thine,map-gpios so that the driver can set it according to
the value given in thine,map in case the HW has a line from some gpio output
to the MAP pin (instead of hardwired hi/low which seem to be your thinking).
Cheers,
Peter
>
> Optional properties:
> - powerdown-gpios: Power down GPIO signal, pin name "/PDWN". Active low
> @@ -36,6 +38,7 @@ Example:
>
> vcc-supply = <®_lvds_vcc>;
> powerdown-gpios = <&gpio4 15 GPIO_ACTIVE_LOW>;
> + thine,map = <1>;
>
> ports {
> #address-cells = <1>;
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
