Hi Shimoda-san,
On Wed, Apr 11, 2018 at 06:37:41PM +0900, Yoshihiro Shimoda wrote:
> This patch adds basic support for the Renesas R-Car E3 (R8A77990) SoC:
> - PSCI
> - CPU (single)
> - Cache controller
> - Main clocks and controller
> - Interrupt controller
> - Timer
> - PMU
> - Reset controller
> - Product register
> - System controller
> - UART for console
>
> Inspried by a patch by Takeshi Kihara in the BSP.
>
> Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
Thanks for your patch. I'd like to request a few minor updates
as per my comments below.
> ---
> arch/arm64/boot/dts/renesas/r8a77990.dtsi | 131 ++++++++++++++++++++++++++++++
> 1 file changed, 131 insertions(+)
> create mode 100644 arch/arm64/boot/dts/renesas/r8a77990.dtsi
>
> diff --git a/arch/arm64/boot/dts/renesas/r8a77990.dtsi b/arch/arm64/boot/dts/renesas/r8a77990.dtsi
> new file mode 100644
> index 0000000..310bfd9
> --- /dev/null
> +++ b/arch/arm64/boot/dts/renesas/r8a77990.dtsi
> @@ -0,0 +1,131 @@
> +/* SPDX-License-Identifier: GPL-2.0 */
> +/*
> + * Device Tree Source for the r8a77990 SoC
> + *
> + * Copyright (C) 2018 Renesas Electronics Corp.
> + */
> +
> +#include <dt-bindings/clock/renesas-cpg-mssr.h>
> +#include <dt-bindings/interrupt-controller/arm-gic.h>
> +
> +/ {
> + compatible = "renesas,r8a77990";
> + #address-cells = <2>;
> + #size-cells = <2>;
> +
> + cpus {
> + #address-cells = <1>;
> + #size-cells = <0>;
> +
> + /* 1 core only at this point */
> + a53_0: cpu@0 {
> + compatible = "arm,cortex-a53", "arm,armv8";
> + reg = <0x0>;
> + device_type = "cpu";
> + power-domains = <&sysc 5>;
> + next-level-cache = <&L2_CA53>;
> + enable-method = "psci";
> + };
> +
> + L2_CA53: cache-controller@0 {
> + compatible = "cache";
> + reg = <0>;
> + power-domains = <&sysc 21>;
> + cache-unified;
> + cache-level = <2>;
> + };
> + };
> +
> + extal_clk: extal {
> + compatible = "fixed-clock";
> + #clock-cells = <0>;
> + /* This value must be overridden by the board */
> + clock-frequency = <0>;
> + };
> +
> + psci {
> + compatible = "arm,psci-0.2";
> + method = "smc";
> + };
> +
> + soc: soc {
> + compatible = "simple-bus";
> + interrupt-parent = <&gic>;
> + #address-cells = <2>;
> + #size-cells = <2>;
> + ranges;
> +
> + gic: interrupt-controller@f1010000 {
> + compatible = "arm,gic-400";
> + #interrupt-cells = <3>;
> + #address-cells = <0>;
> + interrupt-controller;
> + reg = <0x0 0xf1010000 0 0x1000>,
> + <0x0 0xf1020000 0 0x20000>,
> + <0x0 0xf1040000 0 0x20000>,
> + <0x0 0xf1060000 0 0x20000>;
> + interrupts = <GIC_PPI 9
> + (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_HIGH)>;
> + clocks = <&cpg CPG_MOD 408>;
> + clock-names = "clk";
> + power-domains = <&sysc 32>;
> + resets = <&cpg 408>;
> + };
Please sort sub-nodes of the soc node by:
1. Primary key: base address
2. Secondary key: IP block
You can use arch/arm64/boot/dts/renesas/r8a7795.dtsi as a guide.
> +
> + timer {
> + compatible = "arm,armv8-timer";
> + interrupts = <GIC_PPI 13
> + (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_LOW)>,
> + <GIC_PPI 14
> + (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_LOW)>,
> + <GIC_PPI 11
> + (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_LOW)>,
> + <GIC_PPI 10
> + (GIC_CPU_MASK_SIMPLE(1) | IRQ_TYPE_LEVEL_LOW)>;
> + };
> +
> + pmu_a53 {
> + compatible = "arm,cortex-a53-pmu";
> + interrupts = <GIC_SPI 84 IRQ_TYPE_LEVEL_HIGH>;
> + interrupt-affinity = <&a53_0>;
> + };
The timer and pmu_a53 nodes do not have a base address and are thus
not on the bus. Please move them outside of the SoC node.
> +
> + cpg: clock-controller@e6150000 {
> + compatible = "renesas,r8a77990-cpg-mssr";
> + reg = <0 0xe6150000 0 0x1000>;
> + clocks = <&extal_clk>;
> + clock-names = "extal";
> + #clock-cells = <2>;
> + #power-domain-cells = <0>;
> + #reset-cells = <1>;
> + };
> +
> + rst: reset-controller@e6160000 {
> + compatible = "renesas,r8a77990-rst";
> + reg = <0 0xe6160000 0 0x0200>;
> + };
> +
> + prr: chipid@fff00044 {
> + compatible = "renesas,prr";
> + reg = <0 0xfff00044 0 4>;
> + };
> +
> + sysc: system-controller@e6180000 {
> + compatible = "renesas,r8a77990-sysc";
> + reg = <0 0xe6180000 0 0x0400>;
> + #power-domain-cells = <1>;
> + };
> +
> + scif2: serial@e6e88000 {
> + compatible = "renesas,scif-r8a77990",
> + "renesas,rcar-gen3-scif", "renesas,scif";
> + reg = <0 0xe6e88000 0 64>;
> + interrupts = <GIC_SPI 164 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&cpg CPG_MOD 310>;
> + clock-names = "fck";
> + power-domains = <&sysc 32>;
> + resets = <&cpg 310>;
> + status = "disabled";
> + };
> + };
> +};
> --
> 1.9.1
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
