On Thu, Apr 19, 2018 at 12:44:32PM +0300, Vladimir Zapolskiy wrote: Hi Vladimir, > Hi Jacopo, Laurent, > > On 04/10/2018 01:53 PM, Jacopo Mondi wrote: > > Document Thine THC63LVD1024 LVDS decoder device tree bindings. > > > > Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx> > > Reviewed-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx> > > Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx> > > Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> > > Reviewed-by: Vladimir Zapolskiy <vladimir_zapolskiy@xxxxxxxxxx> > > > --- > > .../bindings/display/bridge/thine,thc63lvd1024.txt | 60 ++++++++++++++++++++++ > > 1 file changed, 60 insertions(+) > > create mode 100644 Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt > > > > diff --git a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt > > new file mode 100644 > > index 0000000..0b23e70 > > --- /dev/null > > +++ b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt > > @@ -0,0 +1,60 @@ > > +Thine Electronics THC63LVD1024 LVDS decoder > > +------------------------------------------- > > + > > +The THC63LVD1024 is a dual link LVDS receiver designed to convert LVDS streams > > +to parallel data outputs. The chip supports single/dual input/output modes, > > +handling up to two LVDS input streams and up to two digital CMOS/TTL outputs. > > + > > +Single or dual operation mode, output data mapping and DDR output modes are > > +configured through input signals and the chip does not expose any control bus. > > + > > +Required properties: > > +- compatible: Shall be "thine,thc63lvd1024" > > +- vcc-supply: Power supply for TTL output, TTL CLOCKOUT signal, LVDS input, > > + PPL and digital circuitry > > + > > +Optional properties: > > +- powerdown-gpios: Power down GPIO signal, pin name "/PDWN". Active low > > Thank you for the change. > > I would suggest to rename 'pwdn-gpios' property of THC63LVDM83D as well, > as far as I understand it is only described in DT bindings documentation, > and the property is unused in the driver or board DTS files at the moment. Thanks for the suggestion, I'll do that! > > > +- oe-gpios: Output enable GPIO signal, pin name "OE". Active high > > Okay :) Yeah, please see Rob's and Laurent's reply to v7, where I renamed this to 'enable'. Thanks j > > -- > With best wishes, > Vladimir
Attachment:
signature.asc
Description: PGP signature
