On Wed, Mar 28, 2018 at 03:22:30PM +0100, Phil Edworthy wrote: > The DesignWare GPIO IP can be configured for either 1 or 32 interrupts, > but the driver currently only supports 1 interrupt. See the DesignWare > DW_apb_gpio Databook description of the 'GPIO_INTR_IO' parameter. Someday h/w designers will realize this does nothing to optimize interrupt handling... > This change allows the driver to work with up to 32 interrupts, it will > get as many interrupts as specified in the DT 'interrupts' property. > It doesn't do anything clever with the different interrupts, it just calls > the same handler used for single interrupt hardware. > > Signed-off-by: Phil Edworthy <phil.edworthy@xxxxxxxxxxx> > --- > Note: There are a few lines over 80 chars, but this is just guidance, right? > Especially as there are already some lines over 80 chars. Code, yes, but not for paragraphs of text in DT bindings. > --- > .../devicetree/bindings/gpio/snps-dwapb-gpio.txt | 10 ++++- > drivers/gpio/gpio-dwapb.c | 44 +++++++++++++++++----- > include/linux/platform_data/gpio-dwapb.h | 3 +- > 3 files changed, 45 insertions(+), 12 deletions(-) > > diff --git a/Documentation/devicetree/bindings/gpio/snps-dwapb-gpio.txt b/Documentation/devicetree/bindings/gpio/snps-dwapb-gpio.txt > index 4a75da7..e343581 100644 > --- a/Documentation/devicetree/bindings/gpio/snps-dwapb-gpio.txt > +++ b/Documentation/devicetree/bindings/gpio/snps-dwapb-gpio.txt > @@ -26,8 +26,14 @@ controller. > the second encodes the triger flags encoded as described in > Documentation/devicetree/bindings/interrupt-controller/interrupts.txt > - interrupt-parent : The parent interrupt controller. > -- interrupts : The interrupt to the parent controller raised when GPIOs > - generate the interrupts. > +- interrupts : The interrupts to the parent controller raised when GPIOs > + generate the interrupts. If the controller provides one combined interrupt > + for all GPIOs, specify a single interrupt. If the controller provides one > + interrupt for each GPIO, provide a list of interrupts that correspond to each > + of the GPIO pins. When specifying multiple interrupts, if any of the GPIOs are > + not connected to an interrupt, use the interrupt-mask property. > +- interrupt-mask : a 32-bit bit mask that specifies which interrupts in the list > + of interrupts is valid, bit is 1 for a valid irq. This is not a standard property and would need a vendor prefix. However, I'd prefer you just skip any not connected interrupts with an invalid interrupt number. Then the GPIO number is the index into "interrupts". > - snps,nr-gpios : The number of pins in the port, a single cell. This BTW should be deprecated to use "nr-gpios" instead, but that's another patch. > - resets : Reset line for the controller. > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
