On Thu, 2018-03-22 at 10:58 +0800, Zhiyong Tao wrote:
> For generic pins, parameter "arg" is 0 or 1.
> For special pins, bias-disable is set by R0R1,
> so we need transmited "00" to set bias-disable
> When we set "bias-disable" as high-z property,
> the parameter should be "MTK_PUPD_SET_R1R0_00".
>
> Signed-off-by: Zhiyong Tao <zhiyong.tao@xxxxxxxxxxxx>
> ---
> drivers/pinctrl/mediatek/pinctrl-mtk-common.c | 8 ++++++--
> 1 file changed, 6 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pinctrl/mediatek/pinctrl-mtk-common.c b/drivers/pinctrl/mediatek/pinctrl-mtk-common.c
> index 3cf384f..f991ff3 100644
> --- a/drivers/pinctrl/mediatek/pinctrl-mtk-common.c
> +++ b/drivers/pinctrl/mediatek/pinctrl-mtk-common.c
> @@ -293,7 +293,7 @@ static int mtk_pconf_set_pull_select(struct mtk_pinctrl *pctl,
> unsigned int pin, bool enable, bool isup, unsigned int arg)
> {
> unsigned int bit;
> - unsigned int reg_pullen, reg_pullsel;
> + unsigned int reg_pullen, reg_pullsel, r1r0;
> int ret;
>
> /* Some pins' pull setting are very different,
> @@ -301,8 +301,12 @@ static int mtk_pconf_set_pull_select(struct mtk_pinctrl *pctl,
> * resistor bit, so we need this special handle.
> */
> if (pctl->devdata->spec_pull_set) {
> + /* For special pins, bias-disable is set by R1R0,
> + * the parameter should be "MTK_PUPD_SET_R1R0_00".
> + */
> + r1r0 = enable ? arg : MTK_PUPD_SET_R1R0_00;
> ret = pctl->devdata->spec_pull_set(mtk_get_regmap(pctl, pin),
> - pin, pctl->devdata->port_align, isup, arg);
> + pin, pctl->devdata->port_align, isup, r1r0);
> if (!ret)
> return 0;
> }
Reviewed-by: Sean Wang <sean.wang@xxxxxxxxxxxx>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
