Hi Rob,
sorry I used allwinner,sunxi-pinctrl.txt from Maxime Ripard as a base, I
used the same words, I thought it would be correct.
I will modify this to:
The BCM2835 pin configuration and multiplexing supports the generic
bindings. For details on each properties, you can refer to
./pinctrl-bindings.txt.
If it's okay for you let me know, so I can send the v5 patch.
Best Regards
Matheus Castello
On 03/18/2018 08:48 AM, Rob Herring wrote:
On Fri, Mar 09, 2018 at 01:13:58PM -0400, Matheus Castello wrote:
Added generic pin configuration and multiplexing support,
and shoud be preferred than brcm legacy one.
Signed-off-by: Matheus Castello <matheus@xxxxxxxxxxxxxxx>
---
.../devicetree/bindings/pinctrl/brcm,bcm2835-gpio.txt | 19 +++++++++++++++++++
1 file changed, 19 insertions(+)
diff --git a/Documentation/devicetree/bindings/pinctrl/brcm,bcm2835-gpio.txt b/Documentation/devicetree/bindings/pinctrl/brcm,bcm2835-gpio.txt
index 2569866..58b4720 100644
--- a/Documentation/devicetree/bindings/pinctrl/brcm,bcm2835-gpio.txt
+++ b/Documentation/devicetree/bindings/pinctrl/brcm,bcm2835-gpio.txt
@@ -36,6 +36,25 @@ listed. In other words, a subnode that lists only a mux function implies no
information about any pull configuration. Similarly, a subnode that lists only
a pul parameter implies no information about the mux function.
+This driver supports the generic pin multiplexing and configuration
Bindings describe h/w, not drivers.
+bindings. For details on each properties, you can refer to
+./pinctrl-bindings.txt.
+
+Required sub-node properties:
+ - pins
+ - function
+
+Optional sub-node properties:
+ - bias-disable
+ - bias-pull-up
+ - bias-pull-down
+ - output-high
+ - output-low
+
+Legacy pin configuration and multiplexing binding:
+*** (Its use is deprecated, use generic multiplexing and configuration
+bindings instead)
+
Required subnode-properties:
- brcm,pins: An array of cells. Each cell contains the ID of a pin. Valid IDs
are the integer GPIO IDs; 0==GPIO0, 1==GPIO1, ... 53==GPIO53.
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
