* Rob Herring <robh@xxxxxxxxxx> [180219 20:41]:
> On Sat, Feb 17, 2018 at 01:07:23PM -0800, Tony Lindgren wrote:
> > The GPIOs controlling MDM6600 are used to power MDM660 on and off, to
>
> MDM660 a typo?
Thanks fixing.
> > +Required properties:
> > +- compatible Must be "motorola,mapphone-mdm6600"
> > +- enable-gpios GPIO to enable the USB PHY
> > +- power-gpios GPIO to power on the device
> > +- reset-gpios GPIO to reset the device
>
> The are pretty standard, but...
>
> > +- mode-gpios Two GPIOs to configure MDM6600 USB start-up mode for
> > + normal mode versus USB flashing mode
> > +- status-gpios Three GPIOs to read the power state of the MDM6600
> > +- cmd-gpios Three GPIOs to control the power state of the MDM6600
>
> These 3 should have vendor a prefix.
OK
> > +
> > +Example:
> > +
> > +fsusb1_phy: fsusb1_phy {
>
> usb-phy {
Thanks will send out an updated version shortly.
Regards,
Tony
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
