Add options for enabling RS485 hardware control and configuring Driver Enable signal: - rs485-rts-delay - rs485-rx-during-tx - rs485-rts-active-low - linux,rs485-enabled-at-boot-time Signed-off-by: Bich Hemon <bich.hemon@xxxxxx> --- Documentation/devicetree/bindings/serial/st,stm32-usart.txt | 2 ++ 1 file changed, 2 insertions(+) diff --git a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt index aaeb564..81e0011 100644 --- a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt +++ b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt @@ -16,6 +16,8 @@ Required properties: Optional properties: - pinctrl: The reference on the pins configuration - st,hw-flow-ctrl: bool flag to enable hardware flow control. +- rs485-rts-delay, rs485-rx-during-tx, rs485-rts-active-low, + linux,rs485-enabled-at-boot-time: see rs485.txt. - dmas: phandle(s) to DMA controller node(s). Refer to stm32-dma.txt - dma-names: "rx" and/or "tx" - wakeup-source: bool flag to indicate this device has wakeup capabilities -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
