On Friday 23 February 2018 16:03:53 Shawn Guo wrote:
> On Thu, Feb 01, 2018 at 07:31:25PM +0100, Lucas Stach wrote:
> > +&usdhc1 {
> > + pinctrl-names = "default", "state_100mhz", "state_200mhz";
> > + pinctrl-0 = <&pinctrl_usdhc1_cd_reset>, <&pinctrl_usdhc1_clk_strobe>,
> > + <&pinctrl_usdhc1_data>;
> > + pinctrl-1 = <&pinctrl_usdhc1_cd_reset>,
> > + <&pinctrl_usdhc1_clk_strobe_100mhz>,
> > + <&pinctrl_usdhc1_data_100mhz>;
> > + pinctrl-2 = <&pinctrl_usdhc1_cd_reset>,
> > + <&pinctrl_usdhc1_clk_strobe_200mhz>,
> > + <&pinctrl_usdhc1_data_200mhz>;
> > + vqmmc-supply = <&sw4_reg>;
> > + bus-width = <8>;
> > + non-removable;
> > + no-sd;
> > + no-sdio;
> > + status = "okay";
> > +};
>
> I'm not sure it can be enabled right now. Per my testing, eMMC is not
> working yet.
>
> [ 0.879756] mmc0: Switching to 3.3V signalling voltage failed
> [ 0.913587] mmc0: SDHCI controller on 30b40000.usdhc [30b40000.usdhc]
> using ADMA ...
> [ 1.007628] mmc0: switch to high-speed from hs200 failed, err:-110
> [ 1.013873] mmc0: error -110 whilst initialising MMC card
> [ 1.020639] mmc0: Switching to 3.3V signalling voltage failed
> ...
> [ 1.132462] mmc0: switch to high-speed from hs200 failed, err:-110
> [ 1.138674] mmc0: error -110 whilst initialising MMC card
> [ 1.145394] mmc0: Switching to 3.3V signalling voltage failed
> [ 1.268367] mmc0: switch to high-speed from hs200 failed, err:-110
> [ 1.274576] mmc0: error -110 whilst initialising MMC card
> [ 1.281291] mmc0: Switching to 3.3V signalling voltage failed
> [ 1.440708] mmc0: switch to high-speed from hs200 failed, err:-110
> [ 1.446919] mmc0: error -110 whilst initialising MMC card
>
> Or am I missing anything?
Property "no-1-8-v;" if no 1.8 V is available?
jb
--
Pengutronix e.K. | Juergen Borleis |
Industrial Linux Solutions | http://www.pengutronix.de/ |
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
