Document the "op_mode" properties parsed from DTS by s2mps11 driver.
S2MPS11/S2MPS14 regulators support different modes of operation:
- Always off;
- On/Off controlled by pin/GPIO (PWREN/LDOEN/EMMCEN);
- Always on;
This is very similar to S5M8767 regulator driver which also supports
opmodes (although S5M8767 have also low-power mode).
Signed-off-by: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
Signed-off-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
Cc: Mark Brown <broonie@xxxxxxxxxx>
Cc: Liam Girdwood <lgirdwood@xxxxxxxxx>
Cc: Tomasz Figa <t.figa@xxxxxxxxxxx>
Cc: devicetree@xxxxxxxxxxxxxxx
Cc: Rob Herring <robh+dt@xxxxxxxxxx>
Cc: Pawel Moll <pawel.moll@xxxxxxx>
Cc: Mark Rutland <mark.rutland@xxxxxxx>
Cc: Ian Campbell <ijc+devicetree@xxxxxxxxxxxxxx>
Cc: Kumar Gala <galak@xxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/mfd/s2mps11.txt | 46 +++++++++++++++++++++
1 file changed, 46 insertions(+)
diff --git a/Documentation/devicetree/bindings/mfd/s2mps11.txt b/Documentation/devicetree/bindings/mfd/s2mps11.txt
index f69bec294f02..ffad6bfe2ebf 100644
--- a/Documentation/devicetree/bindings/mfd/s2mps11.txt
+++ b/Documentation/devicetree/bindings/mfd/s2mps11.txt
@@ -54,6 +54,15 @@ BUCK[3, 4], and BUCK[7, 8, 10]
The regulator constraints inside the regulator nodes use the standard regulator
bindings which are documented elsewhere.
+On S2MPS14 chipset the driver additionally supports "op_mode" properties for
+each regulator.
+ - op_mode: describes the different operating modes of the regulators with
+ power mode change in SOC. The different possible values are,
+ 0 - always off mode
+ 1 - on in normal mode
+ 3 - suspend mode
+ (NOTE: value of 2 is reserved)
+
The following are the names of the regulators that the s2mps11 pmic block
supports. Note: The 'n' in LDOn and BUCKn represents the LDO or BUCK number
as per the datasheet of s2mps11.
@@ -112,3 +121,40 @@ Example:
};
};
};
+
+ s2mps14_pmic@66 {
+ compatible = "samsung,s2mps14-pmic";
+ reg = <0x66>;
+
+ s2m_osc: clocks {
+ compatible = "samsung,s2mps14-clk";
+ #clock-cells = 1;
+ clock-output-names = "xx", "", "zz";
+ };
+
+ regulators {
+ ldo1_reg: LDO1 {
+ regulator-name = "VAP_ALIVE_1.0V";
+ regulator-min-microvolt = <1000000>;
+ regulator-max-microvolt = <1000000>;
+ regulator-always-on;
+ op_mode = <1>; /* Normal Mode */
+ };
+
+ ldo2_reg: LDO2 {
+ regulator-name = "VAP_M1_1.2V";
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1200000>;
+ regulator-always-on;
+ op_mode = <1>; /* Normal Mode */
+ };
+
+ buck1_reg: BUCK1 {
+ regulator-name = "VAP_MIF_1.0V";
+ regulator-min-microvolt = <1000000>;
+ regulator-max-microvolt = <1000000>;
+ regulator-always-on;
+ op_mode = <3>; /* Standby Mode */
+ };
+ };
+ };
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
