Add support for Advantech DMS-BA16 board, which use the Advantech BA-16 module. Signed-off-by: Ken Lin <yungching0725@xxxxxxxxx> --- arch/arm/boot/dts/Makefile | 1 + arch/arm/boot/dts/imx6q-dms-ba16.dts | 154 +++++++++++++++++++++++++++++++++++ 2 files changed, 155 insertions(+) create mode 100644 arch/arm/boot/dts/imx6q-dms-ba16.dts diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile index ade7a38543dc..d97511273f30 100644 --- a/arch/arm/boot/dts/Makefile +++ b/arch/arm/boot/dts/Makefile @@ -428,6 +428,7 @@ dtb-$(CONFIG_SOC_IMX6Q) += \ imx6q-b450v3.dtb \ imx6q-b650v3.dtb \ imx6q-b850v3.dtb \ + imx6q-dms-ba16.dtb \ imx6q-cm-fx6.dtb \ imx6q-cubox-i.dtb \ imx6q-cubox-i-emmc-som-v15.dtb \ diff --git a/arch/arm/boot/dts/imx6q-dms-ba16.dts b/arch/arm/boot/dts/imx6q-dms-ba16.dts new file mode 100644 index 000000000000..4c5e17a17cbd --- /dev/null +++ b/arch/arm/boot/dts/imx6q-dms-ba16.dts @@ -0,0 +1,154 @@ +/* + * Copyright 2018 Advantech Corporation + * + * The code contained herein is licensed under the GNU General Public + * License. You may obtain a copy of the GNU General Public License + * Version 2 or later at the following locations: + * + * http://www.opensource.org/licenses/gpl-license.html + * http://www.gnu.org/copyleft/gpl.html + */ + +/dts-v1/; + +#include <dt-bindings/gpio/gpio.h> +#include "imx6q-ba16.dtsi" + +/ { + model = "Advantech DMS-BA16"; + compatible = "fsl,imx6q-dms-ba16", "fsl,imx6q"; + + clocks { + mclk: clock@0 { + compatible = "fixed-clock"; + reg = <0>; + #clock-cells = <0>; + clock-frequency = <22000000>; + }; + }; + + sound { + compatible = "fsl,imx6q-ba16-sgtl5000", + "fsl,imx-audio-sgtl5000"; + model = "imx6q-ba16-sgtl5000"; + ssi-controller = <&ssi1>; + audio-codec = <&sgtl5000>; + audio-routing = + "MIC_IN", "Mic Jack", + "Mic Jack", "Mic Bias", + "Headphone Jack", "HP_OUT"; + mux-int-port = <1>; + mux-ext-port = <4>; + }; + + reg_usb_otg_vbus: regulator-usbotgvbus { + compatible = "regulator-fixed"; + regulator-name = "usb_otg_vbus"; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_usbotgvbus>; + gpio = <&gpio4 15 GPIO_ACTIVE_HIGH>; + enable-active-high; + }; +}; + +&iomuxc { + + pinctrl_usbotgvbus: usbotgvbusgrp { + fsl,pins = < + MX6QDL_PAD_KEY_ROW4__GPIO4_IO15 0x000b0 + MX6QDL_PAD_GPIO_1__USB_OTG_ID 0x17059 + >; + }; + + pinctrl_i2c1_gpio: i2c1gpiogrp { + fsl,pins = < + MX6QDL_PAD_CSI0_DAT8__GPIO5_IO26 0x1b0b0 + MX6QDL_PAD_CSI0_DAT9__GPIO5_IO27 0x1b0b0 + >; + }; + + pinctrl_i2c2_gpio: i2c2gpiogrp { + fsl,pins = < + MX6QDL_PAD_KEY_COL3__GPIO4_IO12 0x1b0b0 + MX6QDL_PAD_KEY_ROW3__GPIO4_IO13 0x1b0b0 + >; + }; + + pinctrl_i2c3_gpio: i2c3gpiogrp { + fsl,pins = < + MX6QDL_PAD_GPIO_3__GPIO1_IO03 0x1b0b0 + MX6QDL_PAD_GPIO_6__GPIO1_IO06 0x1b0b0 + >; + }; +}; + +&ecspi5 { + fsl,spi-num-chipselects = <1>; + cs-gpios = <&gpio1 17 0>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_ecspi5>; + status = "okay"; + + m25_eeprom: m25p80@0 { + compatible = "atmel,at25"; + spi-max-frequency = <20000000>; + size = <0x8000>; + pagesize = <64>; + reg = <0>; + address-width = <16>; + }; +}; + +&i2c1 { + clock-frequency = <100000>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_i2c1>; + status = "okay"; + + sgtl5000: codec@0a { + compatible = "fsl,sgtl5000"; + reg = <0x0a>; + clocks = <&mclk>; + lrclk-strength = <0x3>; + VDDA-supply = <®_1p8v>; + VDDIO-supply = <®_3p3v>; + }; +}; + +&usbotg { + vbus-supply = <®_usb_otg_vbus>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_usbotg>; + dr_mode = "otg"; + disable-over-current; + status = "okay"; +}; + +&sata { + fsl,no-spread-spectrum; + fsl,transmit-atten-16ths = <12>; + fsl,transmit-boost-mdB = <3330>; + fsl,transmit-level-mV = <1133>; + fsl,receive-dpll-mode = <1>; + status = "okay"; +}; + +&usdhc4 { + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_usdhc4>; + bus-width = <8>; + cd-gpios = <&gpio6 11 1>; + no-1-8-v; + keep-power-in-suspend; + enable-sdio-wakeup; + status = "okay"; +}; + +&pwm2 { + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_pwm2>; + status = "okay"; +}; + -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
