This adds support for the Marvell switch and names the network
ports according to the labels, that can be found next to the
connectors. The switch is connected to the host system using a
PCI based network card.
The PCI bus configuration has been written using the following
information:
root@b650v3# lspci -tv
-[0000:00]---00.0-[01]----00.0 Intel Corporation I210 Gigabit Network Connection
root@b650v3# lspci -nn
00:00.0 PCI bridge [0604]: Synopsys, Inc. Device [16c3:abcd] (rev 01)
01:00.0 Ethernet controller [0200]: Intel Corporation I210 Gigabit Network Connection [8086:1533] (rev 03)
Signed-off-by: Sebastian Reichel <sebastian.reichel@xxxxxxxxxxxxxxx>
---
arch/arm/boot/dts/imx6q-b650v3.dts | 52 ++++++++++++++++++++++++++++++++++++++
1 file changed, 52 insertions(+)
diff --git a/arch/arm/boot/dts/imx6q-b650v3.dts b/arch/arm/boot/dts/imx6q-b650v3.dts
index 7f9f176901d4..5650a9b11091 100644
--- a/arch/arm/boot/dts/imx6q-b650v3.dts
+++ b/arch/arm/boot/dts/imx6q-b650v3.dts
@@ -111,3 +111,55 @@
fsl,tx-cal-45-dp-ohms = <55>;
fsl,tx-d-cal = <100>;
};
+
+&pci_root {
+ /* Intel Corporation I210 Gigabit Network Connection */
+ switch_nic: ethernet@3,0 {
+ compatible = "pci8086,1533";
+ reg = <0x00010000 0 0 0 0>;
+ };
+};
+
+&switch_ports {
+ port@0 {
+ reg = <0>;
+ label = "enacq";
+ phy-handle = <&switchphy0>;
+ };
+
+ port@1 {
+ reg = <1>;
+ label = "eneport1";
+ phy-handle = <&switchphy1>;
+ };
+
+ port@2 {
+ reg = <2>;
+ label = "enix";
+ phy-handle = <&switchphy2>;
+ };
+
+ port@3 {
+ reg = <3>;
+ label = "enid";
+ phy-handle = <&switchphy3>;
+ };
+
+ port@4 {
+ reg = <4>;
+ label = "cpu";
+ ethernet = <&switch_nic>;
+ phy-handle = <&switchphy4>;
+ };
+
+ port@5 {
+ reg = <5>;
+ label = "enembc";
+
+ /* connected to Ethernet MAC of AT91RM9200 in MII mode */
+ fixed-link {
+ speed = <100>;
+ full-duplex;
+ };
+ };
+};
--
2.15.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
