2018-01-11 20:47 GMT+08:00 Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx>:
> Hi,
>
> On Thu, Jan 11, 2018 at 07:34:12PM +0800, hao_zhang wrote:
>> This patch add pwm node for r40.
>>
>> Signed-off-by: hao_zhang <hao5781286@xxxxxxxxx>
>> ---
>> arch/arm/boot/dts/sun8i-r40.dtsi | 13 +++++++++++++
>> 1 file changed, 13 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/sun8i-r40.dtsi b/arch/arm/boot/dts/sun8i-r40.dtsi
>> index 173dcc1..84c963c 100644
>> --- a/arch/arm/boot/dts/sun8i-r40.dtsi
>> +++ b/arch/arm/boot/dts/sun8i-r40.dtsi
>> @@ -295,6 +295,11 @@
>> bias-pull-up;
>> };
>>
>> + pwm_pins: pwm-pins {
>> + pins = "PB2", "PB3";
>> + function = "pwm";
>> + };
>> +
>
> Is it the only combination of pins that is usable?
>
> If so, you can add the pinctrl-0 property directly in the pwm nodes.
>
There are 8 channel pwm of R40/V40/T3, the pins that can be configed to pwm are:
PB2, PB3, PI20, PI21, PB20, PB21, PB9, PB10
PB2, PB3 can be configed on bananapi-m2-ultra and on my T3 board, but
the other pins
is not exist on the board or some pin is confilct with other
functions, so i just add
PB2, PB3. but i think split it is better, just like this :
pwm0_pin: pwm0-pin {
pins = "PB2";
function = "pwm";
};
pwm1_pin: pwm1-pin {
pins = "PB3";
function = "pwm";
};
the node of pwm2~7 should also be added here?
On sun8i-r40-bananapi-m2-ultra.dts:
because of the special customize board, i think just add pinctrl-0 = <&pwm0_pin>
(PB3 I just use to test pwm channel 1)for bananapi-m2-ultra board is enough.
&pwm {
pinctrl-names = "default";
pinctrl-0 = <&pwm0_pin>;
status = "okay";
};
Thanks ;-)
Hao Zhang
> Thanks!
> Maxime
>
> --
> Maxime Ripard, Free Electrons
> Embedded Linux and Kernel engineering
> http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
