Hi Maxime, I'm using a ST board with OV5640 wired in parallel bus output in order to interface to my STM32 DCMI parallel interface. Perhaps could you describe your setup so I could help on understanding the problem on your side. From my past experience with this sensor module, you can first check hsync/vsync polarities, the datasheet is buggy on VSYNC polarity as documented in patch 4/5. Best regards, Hugues. On 01/08/2018 04:38 PM, Maxime Ripard wrote: > Hi Hugues, > > On Wed, Jan 03, 2018 at 10:57:27AM +0100, Hugues Fruchet wrote: >> Enhance OV5640 CSI driver to support also DVP parallel interface. >> Add RGB565 (LE & BE) and YUV422 YUYV format in addition to existing >> YUV422 UYVY format. >> Some other improvements on chip identifier check and removal >> of warnings in powering phase around gpio handling. > > I've been trying to use your patches on top of 4.14, but I cannot seem > to get any signal out of it. > > What is your test setup and which commands are you running? > > Thanks! > Maxime > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
