Hi! [I was waiting for a comment from Rob for the initial submission, but that never came and I nearly forgot. Instead of pinging again, I'm resubmitting with the review comment from Guenter fixed, hoping that Rob will react this time.] This is a workaround for a problem in the AT91 I2C adapter driver (or perhaps the hardware?) when it drives the TWI peripheral on an Atmel sama5d3 chip as I2C. Apparently, that driver can delay in excess of 100 ms just after the transfer of the 7th bit of the last byte. When it does this the I2C bus, when viewed from SMBUS client devices, appears stuck with SCL low. Some SMBUS devices times out under these conditions, in particular temperature sensors. The I2C adapter driver does however not notice the timeout, and thinks the transfer completed successfully when it finally desides to finish the transaction. When this happens, the 8th bit of the last byte is always set, and thus quite possibly corrupted. The chip this was observed with (an nxp SE97) has a means to disable the SMBUS timeout detector, which "fixes" things. Do that. This should probably go to stable? Previous discussion: https://lkml.org/lkml/2017/10/12/227 Changes since v1: https://lkml.org/lkml/2017/10/13/184 - Added #include of bitops.h - Rebased to v4.15-rc1 Cheers, Peter Peter Rosin (2): hwmon: (jc42) optionally try to disable the SMBUS timeout ARM: dts: at91: disable the nxp,se97b SMBUS timeout on the TSE-850 Documentation/devicetree/bindings/hwmon/jc42.txt | 4 ++++ arch/arm/boot/dts/at91-tse850-3.dts | 1 + drivers/hwmon/jc42.c | 21 +++++++++++++++++++++ 3 files changed, 26 insertions(+) -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
