On Mon, Oct 30, 2017 at 8:03 PM, Lin Huang <hl@xxxxxxxxxxxxxx> wrote:
> Document a "reset" and "assert-reset-us", it can be used for
> driver control reset property. And reuse post-power-on-delay-ms
> for deassert reset delay.
>
> Signed-off-by: Lin Huang <hl@xxxxxxxxxxxxxx>
> ---
> Documentation/devicetree/bindings/input/hid-over-i2c.txt | 4 +++-
> 1 file changed, 3 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/devicetree/bindings/input/hid-over-i2c.txt b/Documentation/devicetree/bindings/input/hid-over-i2c.txt
> index 28e8bd8..6ab0eed 100644
> --- a/Documentation/devicetree/bindings/input/hid-over-i2c.txt
> +++ b/Documentation/devicetree/bindings/input/hid-over-i2c.txt
> @@ -31,7 +31,9 @@ device-specific compatible properties, which should be used in addition to the
>
> - vdd-supply: phandle of the regulator that provides the supply voltage.
> - post-power-on-delay-ms: time required by the device after enabling its regulators
> - before it is ready for communication. Must be used with 'vdd-supply'.
> + or deassert reset pin before it is ready for communication.
> +- reset: phandle of the gpio that provides for hid reset pin.
> +- assert-reset-us: the device require reset assert time.
If there was any point in adding the device-specific description
around "wacom,w9013"...then you should probably mention these
properties there too. The idea was to document possible properties
here (where you're adding them already), and to note the property
names under the devices (or so far, just 1 device) that support them.
Or IOW, you need an addition like this:
- compatible:
* "wacom,w9013" (Wacom W9013 digitizer). Supports:
- vdd-supply
- post-power-on-delay-ms
+ - reset-gpios
+ - assert-reset-us
Brian
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
