Enable AP6212a WiFi/BT combo chip on orange-pi-zero-plus2 board: - WiFi SDIO interface is connected to MMC1 - WiFi REG_ON pin connected to gpio PA9: attach to mmc-pwrseq - WiFi HOST_WAKE pin connected to gpio PL7 - BT is connected to UART1 Signed-off-by: Sergey Matyukevich <geomatsi@xxxxxxxxx> --- .../allwinner/sun50i-h5-orangepi-zero-plus2.dts | 32 ++++++++++++++++++++++ 1 file changed, 32 insertions(+) diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts index a42fd79a62a3..d415b7b67cce 100644 --- a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts +++ b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts @@ -64,6 +64,13 @@ regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; }; + + wifi_pwrseq: wifi_pwrseq { + compatible = "mmc-pwrseq-simple"; + pinctrl-names = "default"; + reset-gpios = <&pio 0 9 GPIO_ACTIVE_LOW>; /* PA9 */ + post-power-on-delay-ms = <200>; + }; }; &mmc0 { @@ -75,6 +82,25 @@ status = "okay"; }; +&mmc1 { + pinctrl-names = "default"; + pinctrl-0 = <&mmc1_pins_a>; + vmmc-supply = <®_vcc3v3>; + vqmmc-supply = <®_vcc3v3>; + mmc-pwrseq = <&wifi_pwrseq>; + bus-width = <4>; + non-removable; + status = "okay"; + + brcmf: wifi@1 { + reg = <1>; + compatible = "brcm,bcm4329-fmac"; + interrupt-parent = <&r_pio>; + interrupts = <0 7 IRQ_TYPE_LEVEL_LOW>; /* PL7 */ + interrupt-names = "host-wake"; + }; +}; + &mmc2 { pinctrl-names = "default"; pinctrl-0 = <&mmc2_8bit_pins>; @@ -90,3 +116,9 @@ pinctrl-0 = <&uart0_pins_a>; status = "okay"; }; + +&uart1 { + pinctrl-names = "default"; + pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>; + status = "okay"; +}; -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html