Add the device tree binding documentation for the ov7740 sensor driver.
Signed-off-by: Wenyou Yang <wenyou.yang@xxxxxxxxxxxxx>
---
Changes in v3:
- Explicitly document the "remote-endpoint" property.
Changes in v2: None
.../devicetree/bindings/media/i2c/ov7740.txt | 47 ++++++++++++++++++++++
1 file changed, 47 insertions(+)
create mode 100644 Documentation/devicetree/bindings/media/i2c/ov7740.txt
diff --git a/Documentation/devicetree/bindings/media/i2c/ov7740.txt b/Documentation/devicetree/bindings/media/i2c/ov7740.txt
new file mode 100644
index 000000000000..af781c3a5f0e
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/ov7740.txt
@@ -0,0 +1,47 @@
+* Omnivision OV7740 CMOS image sensor
+
+The Omnivision OV7740 image sensor supports multiple output image
+size, such as VGA, and QVGA, CIF and any size smaller. It also
+supports the RAW RGB and YUV output formats.
+
+The common video interfaces bindings (see video-interfaces.txt) should
+be used to specify link to the image data receiver. The OV7740 device
+node should contain one 'port' child node with an 'endpoint' subnode.
+
+Required Properties:
+- compatible: "ovti,ov7740".
+- reg: I2C slave address of the sensor.
+- clocks: Reference to the xvclk input clock.
+- clock-names: "xvclk".
+
+Optional Properties:
+- reset-gpios: Rreference to the GPIO connected to the reset_b pin,
+ if any. Active low with pull-ip resistor.
+- powerdown-gpios: Reference to the GPIO connected to the pwdn pin,
+ if any. Active high with pull-down resistor.
+
+Endpoint node mandatory properties:
+- remote-endpoint: A phandle to the bus receiver's endpoint node.
+
+Example:
+
+ i2c1: i2c@fc028000 {
+ ov7740: camera@21 {
+ compatible = "ovti,ov7740";
+ reg = <0x21>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_sensor_power &pinctrl_sensor_reset>;
+ clocks = <&isc>;
+ clock-names = "xvclk";
+ assigned-clocks = <&isc>;
+ assigned-clock-rates = <24000000>;
+ reset-gpios = <&pioA 43 GPIO_ACTIVE_LOW>;
+ powerdown-gpios = <&pioA 44 GPIO_ACTIVE_HIGH>;
+
+ port {
+ ov7740_0: endpoint {
+ remote-endpoint = <&isc_0>;
+ };
+ };
+ };
+ };
--
2.13.0
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
