Some interrupts properties are given '0' as the flags argument. Change them to use the appropriate interrupt flags. Signed-off-by: Lothar Waßmann <LW@xxxxxxxxxxxxxxxxxxx> --- arch/arm/boot/dts/imx28-tx28.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/arch/arm/boot/dts/imx28-tx28.dts b/arch/arm/boot/dts/imx28-tx28.dts index 211e67d..52d99b4 100644 --- a/arch/arm/boot/dts/imx28-tx28.dts +++ b/arch/arm/boot/dts/imx28-tx28.dts @@ -329,7 +329,7 @@ pinctrl-names = "default"; pinctrl-0 = <&tx28_pca9554_pins>; interrupt-parent = <&gpio3>; - interrupts = <28 0>; + interrupts = <28 IRQ_TYPE_NONE>; gpio-controller; #gpio-cells = <2>; interrupt-controller; @@ -353,7 +353,7 @@ pinctrl-names = "default"; pinctrl-0 = <&tx28_tsc2007_pins>; interrupt-parent = <&gpio3>; - interrupts = <20 0>; + interrupts = <20 IRQ_TYPE_EDGE_FALLING>; pendown-gpio = <&gpio3 20 GPIO_ACTIVE_LOW>; ti,x-plate-ohms = /bits/ 16 <660>; }; -- 2.1.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
