On Sun, 2017-09-24 at 21:49 +0200, Martin Blumenstingl wrote: > Amlogic Meson GXL SoCs use a dwc3 controller with two USB2 ports, > Meson GXM SoCs use the same dwc3 controller but with three USB3 > ports enabled. Neither of these SoCs has any USB3 port enabled in > the dwc3 registers. > The first USB2 port on both SoCs supports host and peripheral > (also called "device") mode. > > The dwc3 controller supports host mode only. Peripheral mode is > implemented through an additional dwc2 controller (which only enables > device mode). The USB3 PHY has register bits which allow a driver to > detect the current mode - however this is currently not implemented > as the dwc2 controller seems to hang during reset (and I do not have > a use-case where I need peripheral/device mode). > > While the dwc3 controller has no USB3 port enabled we still need the > USB3 PHY to be initialized, otherwise some boards (probably those where > the bootloader does not initialize the USB3 PHY) show errors with > high-speed USB devices connected to any of the USB2 ports. Configuring > the USB_R1_U3H_FLADJ_30MHZ_REG_MASK register as it's done by Amlogic's > vendor GPL kernel sources makes these error go away. > > Thanks to Jerome Brunet for reporting the errors and Neil Armstrong > for discovering that initializing the USB3 PHY fixes these USB errors! > This series works well on the libretech-cc (le potato) For the series: Tested-by: Jerome Brunet <jbrunet@xxxxxxxxxxxx> > > Martin Blumenstingl (2): > dt-bindings: phy: Add support for the USB3 PHY on Amlogic Meson GXL > SoCs > phy: amlogic: add USB3 PHY support for Meson GXL and GXM > > .../devicetree/bindings/phy/meson-gxl-usb3-phy.txt | 19 +++ > drivers/phy/amlogic/Kconfig | 12 ++ > drivers/phy/amlogic/Makefile | 1 + > drivers/phy/amlogic/phy-meson-gxl-usb3.c | 177 > +++++++++++++++++++++ > 4 files changed, 209 insertions(+) > create mode 100644 Documentation/devicetree/bindings/phy/meson-gxl-usb3- > phy.txt > create mode 100644 drivers/phy/amlogic/phy-meson-gxl-usb3.c > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
