From: Hans Verkuil <hans.verkuil@xxxxxxxxx>
Document the bindings for the cec-gpio module for hardware where the
CEC line and optionally the HPD line are connected to GPIO lines.
Signed-off-by: Hans Verkuil <hans.verkuil@xxxxxxxxx>
---
.../devicetree/bindings/media/cec-gpio.txt | 29 ++++++++++++++++++++++
1 file changed, 29 insertions(+)
create mode 100644 Documentation/devicetree/bindings/media/cec-gpio.txt
diff --git a/Documentation/devicetree/bindings/media/cec-gpio.txt b/Documentation/devicetree/bindings/media/cec-gpio.txt
new file mode 100644
index 000000000000..1b7e13f36b08
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/cec-gpio.txt
@@ -0,0 +1,29 @@
+* HDMI CEC GPIO driver
+
+The HDMI CEC GPIO module supports CEC implementations where the CEC line
+is hooked up to a pull-up GPIO line and - optionally - the HPD line is
+hooked up to another GPIO line.
+
+Required properties:
+ - compatible: value must be "cec-gpio".
+ - cec-gpios: gpio that the CEC line is connected to.
+
+If the CEC line is associated with an HDMI receiver/transmitter, then the
+following property is also required:
+
+ - hdmi-phandle - phandle to the HDMI controller, see also cec.txt.
+
+If the CEC line is not associated with an HDMI receiver/transmitter, then
+the following property is optional:
+
+ - hpd-gpios: gpio that the HPD line is connected to.
+
+Example for the Raspberry Pi 3 where the CEC line is connected to
+pin 26 aka BCM7 aka CE1 on the GPIO pin header and the HPD line is
+connected to pin 11 aka BCM17:
+
+cec-gpio {
+ compatible = "cec-gpio";
+ cec-gpio = <&gpio 7 GPIO_OPEN_DRAIN>;
+ hpd-gpio = <&gpio 17 GPIO_ACTIVE_HIGH>;
+};
--
2.14.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
