Re: [PATCHv3 3/5] dt-bindings: document the CEC GPIO bindings

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 31/08/17 11:20, Linus Walleij wrote:
> On Wed, Aug 30, 2017 at 6:10 PM, Hans Verkuil <hverkuil@xxxxxxxxx> wrote:
> 
>> From: Hans Verkuil <hans.verkuil@xxxxxxxxx>
>>
>> Document the bindings for the cec-gpio module for hardware where the
>> CEC pin and optionally the HPD pin are connected to GPIO pins.
>>
>> Signed-off-by: Hans Verkuil <hans.verkuil@xxxxxxxxx>
> 
> I usually refer to GPIO "lines" rather than "pins" for clarity.
> It's because some systems also have pin control, and then it becomes
> a bit muddy what is a pin.

I'll change the terminology.

>> +* HDMI CEC GPIO driver
>> +
>> +The HDMI CEC GPIO module supports CEC implementations where the CEC pin
>> +is hooked up to a pull-up GPIO pin and - optionally - the HPD pin is
>> +hooked up to a pull-down GPIO pin.
>> +
>> +Required properties:
>> +  - compatible: value must be "cec-gpio"
>> +  - cec-gpio: gpio that the CEC line is connected to
>> +
>> +Optional property:
>> +  - hpd-gpio: gpio that the HPD line is connected to
>> +
>> +Example for the Raspberry Pi 3 where the CEC line is connected to
>> +pin 26 aka BCM7 aka CE1 on the GPIO pin header and the HPD line is
>> +connected to pin 11 aka BCM17:
>> +
>> +cec-gpio@7 {
>> +       compatible = "cec-gpio";
>> +       cec-gpio = <&gpio 7 GPIO_ACTIVE_HIGH>;
>> +       hpd-gpio = <&gpio 17 GPIO_ACTIVE_HIGH>;
>> +};
> 
> So what I understood from the driver is that the cec-gpio is maybe actually
> an open drain output line, so in that case it should be stated in the docs and
> cec-gpio  = <&gpio 7 GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN>
> or GPIO_LINE_OPEN_DRAIN if it is not also single-ended.

Yes, I agree, it's open drain. I'm not sure whether or not it is single-ended.
I'm not sure what the difference is, and I have no electronics background.

Looking at fwnode_get_named_gpiod() it seems that it has to be single-ended
for GPIO_OPEN_DRAIN to be set, so I am going with that. It works, so it is
probably right :-)

Regards,

	Hans
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux