On 08/26, Shawn Guo wrote: > On Fri, Aug 25, 2017 at 04:18:18PM -0700, Stephen Boyd wrote: > > > > Right. Does the GPIO work? If so, it sounds like the read/write > > access checks in spmi pmic arb don't work properly. > > The check works. With the check in there, PM8916 GPIO doesn't work. > However, the consequence is that not only user3 but all GPIO leds under > 'leds' node will fail to register, because any GPIO led's failing on > create_gpio_led() makes leds-gpio driver probe fail as a while. That's > how leds-gpio driver works. > > Also, per schematics, PM8916 GPIO1 is indeed routed to user3 LED on > db410c board. Why do you think apq8016-sbc device tree shouldn't use > the GPIO for that at all? Isn't it firmware's fault that the ownership > of the peripheral is not properly configured? If the ownership was not properly configured in the firmware, then I imagine it would mean that we can't control the GPIO for the LED. But that doesn't seem to be true. I can see on my board that I get impermissible write failures on the GPIO when controlling the GPIO brightness, but it doesn't actually matter because the led still lights up. So the checks for write/read permission seem incorrect, or they're not being enforced. Anyway, I just wanted to make sure the GPIO still works, and it looks like it does, so removing the permission checks is enough to make me happy. -- Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, a Linux Foundation Collaborative Project -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
