Hi Loic, > Add basic support for Broadcom serial slave devices. > Probe the serial device, retrieve its maximum speed and > register a new hci uart device. > > Tested/compatible with bcm43438 (RPi3). > > Signed-off-by: Loic Poulain <loic.poulain@xxxxxxxxx> > --- > v2: dt-bindings as separate patch > rebase on upcoming pi3 dts changes > v3: changes in bcm serdev drivers: > name refactoring and additional comments > Add generic host_set_baudrate method > Use agnostic device_property_read > v4: changes in doc and dts: > Add additional params to broadcom bt dt-bindings > Set the max baudrate to 2000000 instead of 921600 > use chosen/stdout-path instead of console= > remove useless earlyprintk > same changes in bcm283x.dtsi > > drivers/bluetooth/hci_bcm.c | 85 +++++++++++++++++++++++++++++++++++++++++++-- > 1 file changed, 83 insertions(+), 2 deletions(-) I decided to amend your patch with the required Kconfig addition and then just applied 1/4 and 4/4 to bluetooth-next tree. For 2/4 and 3/4, I think they should go through the DT tree since they depend on other changes. I can not apply since none of these changes are in any of my parent trees. Regards Marcel -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
