On 2017-08-15 18:28, Christopher Bostic wrote: > On 8/15/17 3:10 AM, Joel Stanley wrote: >> On Tue, Aug 15, 2017 at 4:06 PM, Peter Rosin <peda@xxxxxxxxxx> wrote: >>> On 2017-07-26 19:13, Eddie James wrote: >>>> From: "Edward A. James" <eajames@xxxxxxxxxx> >>>> >>>> This series adds an algorithm for an I2C master physically located on an FSI >>>> slave device. The I2C master has multiple ports, each of which may be connected >>>> to an I2C slave. Access to the I2C master registers is achieved over FSI bus. >>>> >>>> Due to the multi-port nature of the I2C master, the driver instantiates a new >>>> I2C adapter for each port connected to a slave. The connected ports should be >>>> defined in the device tree under the I2C master device. >>> Hmmm, AFAIU fsi is a bus, and on this bus you have some "client" device that >>> happens to be an i2c master, and this is a driver for that "client". Is it >>> totally inconceivable to have some other client device in the future that is >>> implementing an i2c master differently, but still using the fsi bus? >>> >>> With that in mind, is it wise to pick the driver name from the bus that the >>> device is connected to, and nothing else without further qualification? >>> >>> I don't see any "i2c-usb" driver, but I think there are a couple of i2c master >>> drivers that communicate via usb. >> You make a fair point. When I did a prototype of this driver I called >> it i2c-cfam, as it is part of the CFAM hardware unit inside of the >> Power8/Power9 processors. >> >> The documentation does call it FSI_I2CM, so that's an argument for the >> current name. >> >> I'm not sure how accurate that name is. Chris, Eddie, do you have any >> other suggestions? > The I2C engine up to now has been always accessed via the FSI bus so > historically I assume that's why its labelled as FSI_I2CM in the p8/p9 > specs. There isn't any reason this I2C device couldn't be implemented > in some other topology independent of FSI / CFAMs. In other words there > are no FSI details internal to this I2C engine, an argument for removing > the 'FSI' tag. Note that I wasn't primarily concerned with this i2c engine growing some other non-fsi interface (like many devices have both i2c and spi interface versions). I was more concerned with some future and totally different i2c engine that naturally sports a totally different register map but still uses the fsi bus. But you have a point. If this i2c engine evolves and ends up supporting some other interface, then that too would be cause to regret the i2c-fsi name. Cheers, peda -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
