+linuxppc-dev
On Fri, Aug 11, 2017 at 11:29 AM, Robin Murphy <robin.murphy@xxxxxxx> wrote:
> Moving DMA configuration to happen later at driver probe time had the
> unnoticed side-effect that we now perform DMA configuration for *every*
> device represented in DT, rather than only those explicitly created by
> the of_platform and PCI code.
>
> As Christoph points out, this is not really the best thing to do. Whilst
> there may well be other DMA-capable buses that can benefit from having
> their children automatically configured after the bridge has probed,
> there are also plenty of others like USB, MDIO, etc. that definitely do
> not support DMA and should not be indiscriminately processed.
>
> The good news is that DT already gives us the ammunition to do the right
> thing - anything lacking a "dma-ranges" property should be considered
> not to have a mapping of DMA address space from its children to its
> parent, thus anything for which of_dma_get_range() does not succeed does
> not need DMA configuration.
>
> The bad news is that strictly enforcing that would likely break just
> about every FDT platform out there, since most authors have either not
> considered the property at all or have mistakenly assumed that omitting
> "dma-ranges" is equivalent to including the empty property. Thus we have
> little choice but to special-case platform, AMBA and PCI devices so they
> continue to receive configuration unconditionally as before. At least
> anything new will have to get it right in future...
By "anything new", you mean new buses, not new platforms, right?
What's a platform bus device today could be a different kernel bus
type tomorrow with no DT change. So this isn't really enforceable.
I don't completely agree that omitting dma-ranges is wrong and that
new DTs have to have dma-ranges simply because there is much precedent
of DTs with dma-ranges omitted (just go look at PPC). If a bus has no
bus to cpu address translation nor size restrictions, then no
dma-ranges should be allowed. Of course, DT standards can and do
evolve and we could decide to be stricter here, but that hasn't
happened. If it does, then we need to make that clear in the spec and
enforce it.
Rob
>
> Fixes: 09515ef5ddad ("of/acpi: Configure dma operations at probe time for platform/amba/pci bus devices")
> Reported-by: Christoph Hellwig <hch@xxxxxx>
> Signed-off-by: Robin Murphy <robin.murphy@xxxxxxx>
> ---
> drivers/of/device.c | 48 ++++++++++++++++++++++++++++++++----------------
> 1 file changed, 32 insertions(+), 16 deletions(-)
>
> diff --git a/drivers/of/device.c b/drivers/of/device.c
> index e0a28ea341fe..04c4c952dc57 100644
> --- a/drivers/of/device.c
> +++ b/drivers/of/device.c
> @@ -9,6 +9,9 @@
> #include <linux/module.h>
> #include <linux/mod_devicetable.h>
> #include <linux/slab.h>
> +#include <linux/pci.h>
> +#include <linux/platform_device.h>
> +#include <linux/amba/bus.h>
>
> #include <asm/errno.h>
> #include "of_private.h"
> @@ -84,31 +87,28 @@ int of_device_add(struct platform_device *ofdev)
> */
> int of_dma_configure(struct device *dev, struct device_node *np)
> {
> - u64 dma_addr, paddr, size;
> + u64 dma_addr, paddr, size = 0;
> int ret;
> bool coherent;
> unsigned long offset;
> const struct iommu_ops *iommu;
> u64 mask;
>
> - /*
> - * Set default coherent_dma_mask to 32 bit. Drivers are expected to
> - * setup the correct supported mask.
> - */
> - if (!dev->coherent_dma_mask)
> - dev->coherent_dma_mask = DMA_BIT_MASK(32);
> -
> - /*
> - * Set it to coherent_dma_mask by default if the architecture
> - * code has not set it.
> - */
> - if (!dev->dma_mask)
> - dev->dma_mask = &dev->coherent_dma_mask;
> -
> ret = of_dma_get_range(np, &dma_addr, &paddr, &size);
> if (ret < 0) {
> + /*
> + * For legacy reasons, we have to assume some devices need
> + * DMA configuration regardless of whether "dma-ranges" is
> + * correctly specified or not.
> + */
> + if (!dev_is_pci(dev) &&
> +#ifdef CONFIG_ARM_AMBA
> + dev->bus != &amba_bustype &&
> +#endif
> + dev->bus != &platform_bus_type)
> + return ret == -ENODEV ? 0 : ret;
> +
> dma_addr = offset = 0;
> - size = max(dev->coherent_dma_mask, dev->coherent_dma_mask + 1);
> } else {
> offset = PFN_DOWN(paddr - dma_addr);
>
> @@ -129,6 +129,22 @@ int of_dma_configure(struct device *dev, struct device_node *np)
> dev_dbg(dev, "dma_pfn_offset(%#08lx)\n", offset);
> }
>
> + /*
> + * Set default coherent_dma_mask to 32 bit. Drivers are expected to
> + * setup the correct supported mask.
> + */
> + if (!dev->coherent_dma_mask)
> + dev->coherent_dma_mask = DMA_BIT_MASK(32);
> + /*
> + * Set it to coherent_dma_mask by default if the architecture
> + * code has not set it.
> + */
> + if (!dev->dma_mask)
> + dev->dma_mask = &dev->coherent_dma_mask;
> +
> + if (!size)
> + size = max(dev->coherent_dma_mask, dev->coherent_dma_mask + 1);
> +
> dev->dma_pfn_offset = offset;
>
> /*
> --
> 2.13.4.dirty
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
