On Thu, Aug 03, 2017 at 01:01:34PM +0800, Hean Loong, Ong wrote: > From: Ong Hean Loong <hean.loong.ong@xxxxxxxxx> I take back my ack... Laurent's comments on v4 are not addressed. > Device tree binding for Intel FPGA Video and Image > Processing Suite. The binding involved would be generated > from the Altera (Intel) Qsys system. The bindings would > set the max width, max height, buts per pixel and memory > port width. The device tree binding only supports the Intel > Arria10 devkit and its variants. Vendor name retained as > altr. > > Signed-off-by: Ong, Hean Loong <hean.loong.ong@xxxxxxxxx> > --- > .../devicetree/bindings/display/altr,vip-fb2.txt | 39 ++++++++++++++++++++++ > 1 file changed, 39 insertions(+) > create mode 100644 Documentation/devicetree/bindings/display/altr,vip-fb2.txt > > diff --git a/Documentation/devicetree/bindings/display/altr,vip-fb2.txt b/Documentation/devicetree/bindings/display/altr,vip-fb2.txt > new file mode 100644 > index 0000000..c4338d9 > --- /dev/null > +++ b/Documentation/devicetree/bindings/display/altr,vip-fb2.txt > @@ -0,0 +1,39 @@ > +Intel Video and Image Processing(VIP) Frame Buffer II bindings > + > +Supported hardware: Arria 10 and above with display port IP > + > +The hardware associated with this device tree is a SoC FPGA. Where there is an ARM controller > +and a FPGA device. The ARM controller would host the Linux OS while the FPGA device runs on its > +individual IP firmware. In the Intel VIP Frame Buffer II the ARM controller would be > +driving data from the Linux OS to the FPGA device programmed with the Frame Buffer II IP > +to render pixels to be streamed to the Display Port connector. Still referring to Linux as both Laurent and I pointed out. Wrap your lines at <80 chars. This was fine before... > + > +The Frame Buffer II device is a simple frame buffer device. The device contains the display > +properties and the bridge or connector register. The output for this device currently > +is a dedicated to a single Display Port. Currently the max resolution supported is 1280 x 720 at > +60Hz. > + > +More information the FPGA video IP component can be acquired from > +https://www.altera.com/content/dam/altera-www/global/en_US/pdfs/literature/ug/ug_vip.pdf > + > + > +New bindings: > +============= > +Required properties: > +---------------------------- > +- compatible: "altr,vip-frame-buffer-2.0" > +- reg: Physical base address and length of the framebuffer controller's > + registers. > +- altr,max-width: The width of the framebuffer in pixels. > +- altr,max-height: The height of the framebuffer in pixels. > +- altr,mem-port-width = the bus width of the avalon master port on the frame reader > + > +Example: > +---------------------------- > + dp_0_frame_buf: display-controller@100000280 { > + compatible = "altr,vip-frame-buffer-2.0"; > + reg = <0x00000001 0x00000280 0x00000040>; > + altr,max-width = <1280>; > + altr,max-height = <720>; > + altr,mem-port-width = <128>; > + }; > -- > 2.7.4 > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html