This change adds a parameter for the Synopsys 10/100/1000
stmmac Ethernet driver to configure the maximum frame
size supported by the EMAC driver. Synopsys allows the FIFO
sizes to be configured when the cores are built for a particular
device, but do not provide a way for the driver to read
information from the device about the maximum MTU size
supported as limited by the device's FIFO size.
Signed-off-by: Vince Bridgers <vbridgers2013@xxxxxxxxx>
---
V6: respin for updated net-next
V5: simplify comment on use of max-frame-size
V4: add comments to explain use of max-frame-size with respect
to inconsistent definition and use in the ePAPR v1.1 spec
V3: change snps,max-frame-size to max-frame-size
V2: change snps,max-mtu to snps,max-frame-size
---
Documentation/devicetree/bindings/net/stmmac.txt | 3 +++
1 file changed, 3 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/stmmac.txt b/Documentation/devicetree/bindings/net/stmmac.txt
index aefb639..9d92d42 100644
--- a/Documentation/devicetree/bindings/net/stmmac.txt
+++ b/Documentation/devicetree/bindings/net/stmmac.txt
@@ -32,6 +32,8 @@ Optional properties:
- resets: Should contain a phandle to the STMMAC reset signal, if any
- reset-names: Should contain the reset signal name "stmmaceth", if a
reset phandle is given
+- max-frame-size: Maximum Transfer Unit (IEEE defined MTU), rather
+ than the maximum frame size.
Examples:
@@ -42,5 +44,6 @@ Examples:
interrupts = <24 23>;
interrupt-names = "macirq", "eth_wake_irq";
mac-address = [000000000000]; /* Filled in by U-Boot */
+ max-frame-size = <3800>;
phy-mode = "gmii";
};
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
