Hi Keerthy,
On 07/18/2017 05:57 AM, Keerthy wrote:
> Use the devm version of gpiochip_add_data and pass on the
> return value. Reset the static variables to 0 before returning.
>
> Signed-off-by: Keerthy <j-keerthy@xxxxxx>
> ---
> drivers/gpio/gpio-davinci.c | 10 ++++++++--
> 1 file changed, 8 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpio/gpio-davinci.c b/drivers/gpio/gpio-davinci.c
> index 65cb359..2c88054 100644
> --- a/drivers/gpio/gpio-davinci.c
> +++ b/drivers/gpio/gpio-davinci.c
> @@ -166,7 +166,7 @@ static int davinci_gpio_get(struct gpio_chip *chip, unsigned offset)
> static int davinci_gpio_probe(struct platform_device *pdev)
> {
> static int ctrl_num, bank_base;
> - int gpio, bank;
> + int gpio, bank, ret = 0;
> unsigned ngpio, nbank;
> struct davinci_gpio_controller *chips;
> struct davinci_gpio_platform_data *pdata;
> @@ -232,7 +232,13 @@ static int davinci_gpio_probe(struct platform_device *pdev)
> for (gpio = 0, bank = 0; gpio < ngpio; gpio += 32, bank++)
> chips->regs[bank] = gpio_base + offset_array[bank];
>
> - gpiochip_add_data(&chips->chip, chips);
> + ret = devm_gpiochip_add_data(dev, &chips->chip, chips);
> + if (ret) {
> + ctrl_num = 0;
> + bank_base = 0;
Hmm, this doesn't look right to me. These variables are defined as
static, and you are resetting them unconditionally. This should be an
issue when you have multiple devices and one of them fails.
regards
Suman
> + return ret;
> + }
> +
> platform_set_drvdata(pdev, chips);
> davinci_gpio_irq_setup(pdev);
> return 0;
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
