On Mon, Jul 03, 2017 at 10:51:51AM +0300, Andy Shevchenko wrote: > On Mon, Jul 3, 2017 at 1:40 AM, Hauke Mehrtens <hauke@xxxxxxxxxx> wrote: > > From: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> > > > > The reset controllers (on xRX200 and newer SoCs have two of them) are > > provided by the RCU module. This was initially implemented as a simple > > reset controller. However, the RCU module provides more functionality > > (ethernet GPHYs, USB PHY, etc.), which makes it a MFD device. > > The old reset controller driver implementation from > > arch/mips/lantiq/xway/reset.c did not honor this fact. > > > > For some devices the request and the status bits are different. > > > +Required properties: > > +- compatible : Should be one of > > + "lantiq,danube-reset" > > + "lantiq,xrx200-reset" > > +- offset-set : Offset of the reset set register > > +- offset-status : Offset of the reset status register > > Just one side comment (I'm fine with either choice, just for your > information). Recently I have reviewed at24 patch which adds a > property for getting MAC offset and my reseach ends up with the naming > pattern mac-offset (as many others are doing this way). So, perhaps in > your case it might make sense to do that way? Anyway, it's a matter of > a (bit of a) chaos in DT bindings, whatever you decide users will live > with. Not a pattern I want to standardize. Describing offsets is generally an indication of the compatible not being specific enough. Rob -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
