Add nodes of thermal monitor and thermal zone for UniPhier LD20 SoC.
The thermal monitor is included in sysctrl.
Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@xxxxxxxxxxxxx>
---
arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi | 40 ++++++++++++++++++++++++
1 file changed, 40 insertions(+)
diff --git a/arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi b/arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi
index a6b3a70..22d04111 100644
--- a/arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi
+++ b/arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi
@@ -82,6 +82,7 @@
clocks = <&sys_clk 32>;
enable-method = "psci";
operating-points-v2 = <&cluster0_opp>;
+ #cooling-cells = <2>;
};
cpu1: cpu@1 {
@@ -100,6 +101,7 @@
clocks = <&sys_clk 33>;
enable-method = "psci";
operating-points-v2 = <&cluster1_opp>;
+ #cooling-cells = <2>;
};
cpu3: cpu@101 {
@@ -209,6 +211,38 @@
<1 10 4>;
};
+ thermal-zones {
+ cpu_thermal {
+ polling-delay-passive = <250>; /* 250ms */
+ polling-delay = <1000>; /* 1000ms */
+ thermal-sensors = <&pvtctl>;
+
+ trips {
+ cpu_crit: cpu_crit {
+ temperature = <110000>; /* 110C */
+ hysteresis = <2000>;
+ type = "critical";
+ };
+ cpu_alert: cpu_alert {
+ temperature = <100000>; /* 100C */
+ hysteresis = <2000>;
+ type = "passive";
+ };
+ };
+
+ cooling-maps {
+ map0 {
+ trip = <&cpu_alert>;
+ cooling-device = <&cpu0 (-1) (-1)>;
+ };
+ map1 {
+ trip = <&cpu_alert>;
+ cooling-device = <&cpu2 (-1) (-1)>;
+ };
+ };
+ };
+ };
+
soc {
compatible = "simple-bus";
#address-cells = <1>;
@@ -417,6 +451,12 @@
compatible = "socionext,uniphier-ld20-reset";
#reset-cells = <1>;
};
+
+ pvtctl: pvtctl {
+ compatible = "socionext,uniphier-ld20-thermal";
+ interrupts = <0 3 4>;
+ #thermal-sensor-cells = <0>;
+ };
};
};
};
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
