On Tue, Jun 20, 2017 at 02:40:57PM +0530, Varadarajan Narayanan wrote: > Currently the QUP Version v1 does not work with DMA so added > the support for the same. > > 1. It uses ADM DMA which requires TX and RX CRCI > 2. DMA channel initialization need to be done after setting > block size for having valid values in maxburst > 3. QUP mode should be DMOV instead of BAM. > > Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx> > Signed-off-by: Varadarajan Narayanan <varada@xxxxxxxxxxxxxx> > --- > .../devicetree/bindings/spi/qcom,spi-qup.txt | 6 ++++ > drivers/spi/spi-qup.c | 35 +++++++++++++++++----- > 2 files changed, 34 insertions(+), 7 deletions(-) > > diff --git a/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt b/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt > index 5c09077..e754181 100644 > --- a/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt > +++ b/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt > @@ -38,6 +38,12 @@ Optional properties: > - dma-names: Names for the dma channels, if present. There must be at > least one channel named "tx" for transmit and named "rx" for > receive. > +- qcom,tx-crci: Identificator for Client Rate Control Interface (CRCI) to be Identificator is not a word. This sounds like something that should be a cell in the dmas property. > + used with TX DMA channel. Required when using DMA for > + transmission with QUP Version 1 i.e qcom,spi-qup-v1.1.1. > +- qcom,rx-crci: Identificator for Client Rate Control Interface (CRCI) to be > + used with RX DMA channel. Required when using DMA for > + receiving with QUP Version 1 i.e qcom,spi-qup-v1.1.1. > > SPI slave nodes must be children of the SPI master node and can contain > properties described in Documentation/devicetree/bindings/spi/spi-bus.txt -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
