Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> writes: > This series adds: > - USB support on Meson8 and Meson8b (it seems that some boards show an > error when trying to initialize one of the USB2 PHYs, but we have the > same problem on some GXBB boards. it is working fine for me - on a board > which is not supported upstream yet) > - hardware random number generator support (Meson8 and Meson8b seem to > have two 32-bit hardware random number generator registers, while the > GX SoCs only have one. This is not handled by the meson-rng driver yet, > but that can still be improved later on) > - SAR ADC support > - add reserved memory zones to fix random hangs when filling the memory > (currently only on Meson8 until I have a Meson8b device to test if the > same problem appears there as well) > - use the real ethernet clock on Meson8 and Meson8b to fix ethernet when > the bootloader does not enable the gate clock > - add the SCU (Snoop Control Unit) which is needed for SMP support > - minor preparations for further .dts updates as this already exports the > SDIO clocks (a driver for this MMC controller is work-in-progress) as > well as the corresponding pin definitions in meson8.dtsi > - this adds the pwm_e (typically used for the 32.768 kHz LPO clock for the > SDIO wifi chip) and pwm_f (used on some boards for the dimmable power > LED) pins to meson8.dtsi > > NOTE: the .dts changes from this series depend on my previous patch from > [0]: "ARM: dts: meson8: fix the IR receiver pins" Thanks for the reminder, I had missed that one. This series now applied to v4.13/dt (after merging in the clock headers deps from Jerome) and will go in the 2nd round of pull requests to arm-soc, probably early next week. Thanks for the continued great work Martin! Kevin -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
