Hi, On Friday 09 June 2017 05:12 PM, Raviteja Garimella wrote: > Changes in V9: > ============= > Rebased on linux-phy next. Driver files and Kconfig/Makefile > changes now in drivers/phy/broadcom. merged the _phy_ patches to linux-phy. Thanks for doing multiple revisions to get it merged. -Kishon > > Changes in v8: > ============= > -Renamed phy shutdown routine > -Used devm_request_irq in stead of threaded irq > -Removed devm_unregister calls in probe routine > > Changes in v7: > ============= > Cleaned up unused variables in phy private data structure that's > missed out in v6. > Setting of phy mode to device/host is removed from phy power on. > routine. > > Changes in v6: > ============= > Removed spin locks which are not required as the references > to phy_ops in the same driver were removed in v5. > > Removed host/device 'notify' routines which are registered > using 'extcon_register_notifier'. The irq handler is sufficient > to deal with the change in extcon events within the same driver. > > Changes in v5: > ============= > Removed references to phy_ops in the same driver by connect_work > event handler to change the phy modes. > > To support dynamically changing the mode of the phy, it does > not require doing a phy reset/programming of PHY PLL. Changes > are made to the connect_work routine to just program the required > register bits to achieve this purpose. > > Changes in v4: > ============= > Remove references to edev->name in debug prints. > > Changes in v3: > ============= > Remove unnecessary checks for poweron as suggested in review. > > Changes in v2: > ============= > 1. Initialize file operations .owner field with THIS_MODULE. > 2. Remove unnecessary gpio example in DT bindings documentation. > This is previously acked by Rob Herring <robh@xxxxxxxxxx> > > Introduction for PATCH v1: > > This patch adds support for USB Dual Role Device Phy for Broadcom > Northstar2 SoC. Apart from the new phy driver, this patchset contains > changes to Kconfig, Makefile, and Device tree files. > > This patchset is tested on Broadcom NS2 BCM958712K reference board. > > Raviteja Garimella (3): > dt-bindings: phy: Add DT bindings documentation for NS2 USB DRD PHY > phy: phy-bcm-ns2-usbdrd: Broadcom USB DRD PHY driver for Northstar2 > arm64: dts: NS2: Add USB DRD PHY device tree node > > .../devicetree/bindings/phy/brcm,ns2-drd-phy.txt | 30 ++ > arch/arm64/boot/dts/broadcom/ns2.dtsi | 14 + > drivers/phy/broadcom/Kconfig | 13 + > drivers/phy/broadcom/Makefile | 1 + > drivers/phy/broadcom/phy-bcm-ns2-usbdrd.c | 437 +++++++++++++++++++++ > 5 files changed, 495 insertions(+) > create mode 100644 Documentation/devicetree/bindings/phy/brcm,ns2-drd-phy.txt > create mode 100644 drivers/phy/broadcom/phy-bcm-ns2-usbdrd.c > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
