From: Joshua Clayton <stillcompiling@xxxxxxxxx>
Previously the onboard hub was made to work by treating its
reset gpio as a regulator enable.
Get rid of that kludge now that pwseq has added reset gpio support
Move pin muxing the hub reset pin into the usbh1 group
Signed-off-by: Joshua Clayton <stillcompiling@xxxxxxxxx>
Signed-off-by: Peter Chen <peter.chen@xxxxxxx>
---
arch/arm/boot/dts/imx6q-evi.dts | 25 +++++++------------------
1 file changed, 7 insertions(+), 18 deletions(-)
diff --git a/arch/arm/boot/dts/imx6q-evi.dts b/arch/arm/boot/dts/imx6q-evi.dts
index fd2220a..24fe093 100644
--- a/arch/arm/boot/dts/imx6q-evi.dts
+++ b/arch/arm/boot/dts/imx6q-evi.dts
@@ -54,18 +54,6 @@
reg = <0x10000000 0x40000000>;
};
- reg_usbh1_vbus: regulator-usbhubreset {
- compatible = "regulator-fixed";
- regulator-name = "usbh1_vbus";
- regulator-min-microvolt = <5000000>;
- regulator-max-microvolt = <5000000>;
- enable-active-high;
- startup-delay-us = <2>;
- pinctrl-names = "default";
- pinctrl-0 = <&pinctrl_usbh1_hubreset>;
- gpio = <&gpio7 12 GPIO_ACTIVE_HIGH>;
- };
-
reg_usb_otg_vbus: regulator-usbotgvbus {
compatible = "regulator-fixed";
regulator-name = "usb_otg_vbus";
@@ -204,12 +192,18 @@
};
&usbh1 {
- vbus-supply = <®_usbh1_vbus>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_usbh1>;
dr_mode = "host";
disable-over-current;
status = "okay";
+
+ usb2415host: hub@1 {
+ compatible = "usb424,2513";
+ reg = <1>;
+ reset-gpios = <&gpio7 12 GPIO_ACTIVE_LOW>;
+ reset-duration-us = <3000>;
+ };
};
&usbotg {
@@ -465,11 +459,6 @@
MX6QDL_PAD_GPIO_3__USB_H1_OC 0x1b0b0
/* usbh1_b OC */
MX6QDL_PAD_GPIO_0__GPIO1_IO00 0x1b0b0
- >;
- };
-
- pinctrl_usbh1_hubreset: usbh1hubresetgrp {
- fsl,pins = <
MX6QDL_PAD_GPIO_17__GPIO7_IO12 0x1b0b0
>;
};
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
