This patch adds the remaining pin functions and mux groups. It also fixes a typo in the existing binding document. Cc: Varadarajan Narayanan <varada@xxxxxxxxxxxxxx> Cc: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> Cc: Ram Chandra Jangir <rjangir@xxxxxxxxxxxxxx> Cc: John Crispin <john@xxxxxxxxxxx> Signed-off-by: Christian Lamparter <chunkeey@xxxxxxxxxxxxxx> --- Note: These definitions were present in the original submission <https://patchwork.kernel.org/patch/7630711/> The DT patch was acked by Rob Herring back then. However, I'm not sure if this is still valid or not. @Rob, can you please comment? Thanks. (Link to Matthew McLintock's v3 that was merged) <https://patchwork.kernel.org/patch/7662241/> --- .../bindings/pinctrl/qcom,ipq4019-pinctrl.txt | 36 ++++++++++++++++++++-- 1 file changed, 34 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/pinctrl/qcom,ipq4019-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/qcom,ipq4019-pinctrl.txt index cfb8500dd56b..4b1c583c51e9 100644 --- a/Documentation/devicetree/bindings/pinctrl/qcom,ipq4019-pinctrl.txt +++ b/Documentation/devicetree/bindings/pinctrl/qcom,ipq4019-pinctrl.txt @@ -39,7 +39,7 @@ information about e.g. the mux function. The following generic properties as defined in pinctrl-bindings.txt are valid to specify in a pin configuration subnode: - pins, function, bias-disable, bias-pull-down, bias-pull,up, drive-strength. + pins, function, bias-disable, bias-pull-down, bias-pull-up, drive-strength. Non-empty subnodes must specify the 'pins' property. Note that not all properties are valid for all pins. @@ -50,7 +50,39 @@ Valid values for qcom,pins are: Supports mux, bias and drive-strength Valid values for qcom,function are: -gpio, blsp_uart1, blsp_i2c0, blsp_i2c1, blsp_uart0, blsp_spi1, blsp_spi0 +gpio, blsp_uart1, blsp_i2c0, blsp_i2c1, blsp_uart0, blsp_spi1, blsp_spi0, +atest_char, atest_char0, atest_char1, atest_char2, atest_char3, +audio_pwm0, audio_pwm1, audio_pwm2, audio_pwm3, aud_pin, +boot2, boot4, boot5, boot7, boot8, boot9, boot11, boot14, boot18, boot19, boot20, +chip_rst, dbg_out, mdc, mdio0, mdio1, pcie_clk, pcie_clk1, +i2s_rx_bclk, i2s_rxd, i2s_rx_fsync, i2s_rx_mclk, i2s_spdif_in, i2s_spdif_out, +i2s_td1, i2s_td2, i2s_td3, i2s_tx_bclk, i2s_tx_fsync, i2s_tx_mclk, +jtag_rst, jtag_tck, jtag_tdi, jtag_tdo, jtag_tms, jtag_trst, +led0, led1, led2, led3, led4, led5, led6, led7, led8, led9, led10, led11, +qdss_cti_trig_out_a0, qdss_cti_trig_out_b0, qdss_traceclk_a, +qdss_tracectl_a, qdss_tracedata_a, pmu0, pmu1, prng_rosc, +qpic_pad, qpic_pad0, qpic_pad1, qpic_pad2, qpic_pad3, +qpic_pad4, qpic_pad5, qpic_pad6, qpic_pad7, qpic_pad8, +rgmii0, rgmii1, rgmii2, rgmii3, rgmii_rx, rgmii_rxc, rgmii_tx, rgmii_txc, +rmii00, rmii01, rmii0_dv, rmii0_refclk, rmii0_rx, rmii0_tx, +rmii10, rmii11, rmii1_dv, rmii1_refclk, rmii1_rx, rmii1_tx, +sdio0, sdio1, sdio2, sdio3, sdio4, sdio5, sdio6, sdio7, sdio_cd, +sdio_clk, sdio_cmd, smart0, smart1, smart2, smart3, +tm0, tm1, tm2, tm3, tm4, tm5, tm6, tm7, tm8, tm9, tm_ack, tm_clk0, +wcss0_dbg, wcss0_dbg4, wcss0_dbg5, wcss0_dbg6, wcss0_dbg7, wcss0_dbg8, +wcss0_dbg9, wcss0_dbg10, wcss0_dbg11, wcss0_dbg12, wcss0_dbg14, wcss0_dbg15, +wcss0_dbg16, wcss0_dbg17, wcss0_dbg18, wcss0_dbg19, wcss0_dbg20, wcss0_dbg21, +wcss0_dbg22, wcss0_dbg23, wcss0_dbg24, wcss0_dbg25, wcss0_dbg26, wcss0_dbg27, +wcss0_dbg28, wcss0_dbg29, wcss0_dbg30, wcss0_dbg31, +wcss1_dbg, wcss1_dbg7, wcss1_dbg8, wcss1_dbg9, wcss1_dbg10, wcss1_dbg11, +wcss1_dbg12, wcss1_dbg16, wcss1_dbg17, wcss1_dbg18, wcss1_dbg19, wcss1_dbg20, +wcss1_dbg21, wcss1_dbg22, wcss1_dbg23, wcss1_dbg24, wcss1_dbg25, wcss1_dbg26, +wcss1_dbg27, wcss1_dbg28, wcss1_dbg29, wcss1_dbg30, wcss1_dbg31, +wifi00, wifi01, wifi02, wifi03, wifi04, wifi034, wifi0_cal, wifi0_rfsilient0, +wifi0_rfsilient1, wifi0_uart, wifi0_uart0, wifi0_uart1, wifi0_wci, +wifi10, wifi11, wifi12, wifi13, wifi14, wifi134, wifi1_cal, wifi1_rfsilient0, +wifi1_rfsilient1, wifi1_uart, wifi1_uart0, wifi1_uart1, wifi1_wci, +wifi_wci0, wifi_wci1 Example: -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
